Jump to content
SAU Community

Recommended Posts

Hi there,

Was removing my radiator today when i noticed from under the car that the clutch fan has a crack in it, on the part that sits around bearing on the motor. See pic:

post-22920-1232813800_thumb.jpg

As you can see, the crack is about 1 cm in size.

Obviously the smart thing to do would be to replace it, but i'm curious if anybody's had a similar issue or a fan fail on them due to cracking.

Also, if anybody's got a spare one lying around that would be great.

Thanks

Link to comment
https://www.sau.com.au/forums/topic/254032-crack-in-clutch-fan/
Share on other sites

just put a bigish thermo on it with a proper shroud.

electric fans get a lot of bad rep but personally i reckon most of this is due the people running them unshrouded and not big enough fans.

for instance i've been looking at fans for my hilux. the one on it was a 16 inch flowing 1000cfm (i think) yet 2x 10inch fans wouldn't flow even close to that.

kinda the same argument such as a single 4 inch pipe will flow more than 2x 2inch pipes by a significant amount, but i get the shits arguing with people about this.

On my r33 i found a crack about the same size as yours. Went for drive that night to get something and the fan split and went into the radiator.

So instead of just having to buy a new clutch fan i also had to buy a new radiator.

Get it replaced as soon as you can as you never know when they will fail.

Where abouts did you get a new one from? I had to trim the blades on the stock one for the intercooler pipe so wouldnt mind buying an aftermarket one that fits on without needing to be trimmed.

Anybody with a Hybrid FMIC know of an aftermarket brand that doesnt require trimming of the blades?

they fatigue after a while.

almost all r31 and vl have this fault as well that i have seen.

i would just double check that the viscous fan centre is working properly, not locked up all the time as this will put extra load onto the blades.

just put a bigish thermo on it with a proper shroud.

electric fans get a lot of bad rep but personally i reckon most of this is due the people running them unshrouded and not big enough fans.

for instance i've been looking at fans for my hilux. the one on it was a 16 inch flowing 1000cfm (i think) yet 2x 10inch fans wouldn't flow even close to that.

kinda the same argument such as a single 4 inch pipe will flow more than 2x 2inch pipes by a significant amount, but i get the shits arguing with people about this.

A 16inch SPAL fan from PWR will flow 3000cfm. I don't know of any that flow higher but they are good value if you are having cooling issues and they can't be fixed by the normal maintenance procedures.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Holy shit, I'm glad you brought up the battery issue and I'm glad I asked about measuring it. Old battery was at a healthy 12.82V in the morning with the car turned off. Removed the fuel pump fuse, clamped the multimeter on at min/max/average and cranked for ~3 seconds. It dropped down to 8.30V. So yeah, not surprising it struggled that much. Picked up a fresh battery from supercheap and it's ridiculous. Haven't done a cold start yet, but man, even with a warm start the difference is night and day. I can't believe I lived with this for so long. Just blamed it on it being an old modified car. Went with Century because convenient. If they are shit it'll be a future me problem. But just in case I set up a reminder for 30 months - 8 weeks to check on the battery state and get a warranty replacement if necessary. 
    • There's another sensor that sits inside the evaporator, that's a C U N T to get to, but can be done without removing the entire unit. Usually it's not the sensor that dies but the actual capacitor in the circuit (part of the plug that dies).  
    • Putting the climate control CU into diagnostic mode is independent of the ECU. You just have to do the dance prescribed in the manual. No, I do not know what the dance is. I have an R32, so use the dance in the R32 manual. On older cars, I would have said "no, the ECU should not affect whether the A/C works".... but for an R34 that might be wrong. I don't recall the detail, but there was extra mods required to make my R32 A/C work against the R34 ECU. The R34 ECU apparently gets involved in the running of the A/C more than earlier cars did. Theoretically, if the PFC is a true plug in, then it should just work the way that the original ECU does - wrt A/C. But there's always scope for them to have not cared. Nope. Pressure switch out = getting the fridgey out to pump the gas out before pulling the switch. The switch really cannot sense gas pressure unless it is up against the gas.
    • Hi guys, thanks for the replies.  I will have to wait till summer to test properly, but it short cycles both when heating and cooling. I’ve ordered a new internal temp sensor that sits under the vent in the steering wheel also, GTSBOY, I have an Apexi FC ecu, I’m assuming I won’t be able to diagnose or would it still work? Could the ecu be causing the problem??   the pressure switch is quite cheap I will get a new one and try it out, hopefully it doesn’t require purging the refrigerant again?
×
×
  • Create New...