Headlight [Hi Beams]

[jtech]

ok this is easy..

low beam, outside headlights are on

high beam, inside lights are on...

never both

any ideas?

[Craved]

Just the way they are, have seen some places selling kits tohave both on at the same time, cant remember where though.

IMOH they look cool seperate, and very handy when you want someone to move out of the way at night

[(B1) MR_fanny]

thats just how a skyline works

[Muz]

not mine ........ all light up on hi beam

[Guest RedLineGTR]

not sure about r34's but i know that is the deal on r33's u can get a kit to make them both work at the same time...or if your good with electronics then it shouldnt be a problem.

[WazR32GTSt]

i have an r32 and on high-beams both light up...

[jtech]

my frens r33 gtr both light up... the rego ppl said it ISNT legal for only 2 to lite up on hi beam, must be all of them.... owel

i made a walkthrough on how to take the front bar off.. with pics, will post soon... might make a Hibeam fix aswel

[blind_elk]

That's crap. Tell him to check the ADRs (ADR 13/00).

For Main-beam (ie high beam):

6.1.7.1. The main-beam headlamps may be switched on either simultaneously or in pairs. For changing over from the dipped to the main beam at least one pair of main-beam headlamps shall be switched on. For changing over from the main-beam to the dipped- beam all main-beam headlamps shall be switched off simultaneously.

6.1.7.2. The dipped-beams may remain switched on at the same time as the mainbeams.

For dipped (low) beam:

6.2.7. Electrical connections

The control for changing over to the dipped beam must switch off all main-beam headlamps simultaneously.

The dipped beams may remain switched on at the same time as the main beams.

[Duncan]

Thanks for that blind_elk, the d1ck who did my rego said the same thing. Know better next time

[AutoTrust]

Locate the wiring on your steering column that controls high and low beam ( use a test light or volt meter). get a standard relay. locate the power wire in the same harness and run a wire from this to pin 30 on the relay. then run a wire from pin 85 on the relay to a good earth point under the dash. run a wire from the high beam to 86 and finally the low beam wire to pin 87. this will energise the low beam circuit when high beam is on and give you better light when high beam is selected.

[Airzone]

Hi,

There are instructions and pictures here:

http://www.skylinesaustralia.com/forums/sh...25&pagenumber=1

Happy modding

[ron]

quite easy to modify actually.

but for dummies. try hold the lever halfway and youll get both low/high bean contacts going which will light up all 4. try

ron

[streamer]

when 2 lights are turned on, i read somewhere that it will discharge too much heat and might...read "might" possibly melt the headlight covers.

if im not mistaken, R33's were designed this way, to have the outside ones on with the normal beam and the inside ones on when on high beam and there are instances when u can use a relay to get both to go on.

haven't done it. wd love to but waiting fer someone to get it goin and see how it goes...dont quite enjoy being a guiniea pig

hehh

l)

[pushead]

im sure nissan didn't design R33's to have all 4 lights on for a reason

[Airzone]

It's been working fine for me for 6 months, and my lights haven't burnt out. I don't drive around with the high beam on all the time though - only when it's needed.