Jump to content
SAU Community

Inner West Crew Whoretown (toowong/st Lucia/kenmore/indooroopilly And Sometimes Sunnybank?)


funkymonkey

Recommended Posts

seen it mate, got photos of it sliding to, but i'll raise by not 1 but 2

79904802_full.jpg

1JZ-fitting-13.jpg

^^^ this is my inspiration to my next 32

and as for that fuel pump i got a $10 solution for ya in my pile.

haha yeh I saw his drift pics.

I'd buy it, even just as a tester, but I cannot get out to get it. My car is garage bound, end of my street and it dies. I can get to toowong shopping centre by city cat, about as far as I can go

Link to comment
Share on other sites

haha yeh I saw his drift pics.

I'd buy it, even just as a tester, but I cannot get out to get it. My car is garage bound, end of my street and it dies. I can get to toowong shopping centre by city cat, about as far as I can go

i could bring the pump somewhere and meet you? try get as far as you can with ur 32 and we'll replace the pump on the side of the road LOL.

Link to comment
Share on other sites

Hey Colin,

You know how you hate me and stuff? Well... I just went to McDonalds... and wound up having the counter girl for dessert :worship::(

You picked up at Maccas.....wow..

Maccas...

If it was Hungry Jacks, then hi 5 time, but Maccas. :worship:

Link to comment
Share on other sites

+1

The chick on the drive through at HJs was a stunner. No desert for me though :yes:

Thats because you drive a skyline, if you had a commy with fully sick chrome wheels and 15 subwoofers then she would have been out the window like a flash.

Link to comment
Share on other sites

*sigh*

T88 install update:

- Fuel filter looked fine

- There is some grit in the tank, not enough to warrant pulling the tank out

- Fuel pump is the original item still had all factory seals

The pump filter that sits in the thank is brown and had gritty alloy looking rubbish on it (I assume from the alloy nozzles at fuel stations. I'm hoping it's just a case of a 20 year old pump :yes:

Now taking bets I might have f**ked something

- Standard one way valve after the fuel filter, before the injectors perhaps?

Link to comment
Share on other sites

Dave:

As far as I know my car still has the AUTO ecu, do you have one of your manual ones you can check the numbers on?? I have no idea what numbers you need (if you know let me know and i'll get my ones).

If i do indeed still have the auto one.. I'll take one of those manual puppies too

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Got bored took photos of the sub I made. Original enclosure had 2x 10" Peerless drivers in an Isobaric configuration.  Although sounding nice, wasn't good for movies so I took both drivers out and sold them and replaced it with a single Dayton 10" HF series driver. The front baffled needed to be enlarged to fit the driver (something I didn't account for lol). Then of course the original 150W RMS Jaycar plate amps wasn't up to scratch and the driver would clip/bottom out, so an O-Audio 500W RMS plate amp was fitted. A year later, got bored and wanted more output, used WinISD and calculated I would get about -3dB roll of at about 21Hz with a 4" port and I think about 30cm long or so. Has been like that for over a decade, until a few months ago the amp would randomly hum as though I've taken out the RCA out and earth it against the chassis of the amp. Tested with another sub (Focal Dome, now sold) and RCA nor receiver were the issues. Concluded plate amp is fked. Took the grill off for a photo.  
    • As it is so original, and in mint condition, and they have ceased making 35s, I am thinking of keeping it original (not even going to do the English conversion).   On the other hand, I am looking at Quadzilla mid pipes, Cobb units...
    • Apparently announced on Instagram just this week; I can't access it and nothing on their website Their GTR TCM information is here: https://ecutek.zendesk.com/hc/en-gb/articles/360001830657-Tuning-Your-TCM
    • HA!!! Having the same issue so dropped the car off at Chasers Performance to get the codes.  I could never give it gas while turning. And it stalled at lights for the first time on my way to the mechanic today! 
    • Pretty sure that the Ecutek can also tune the TCM for quicker gear changes as well 
×
×
  • Create New...