Jump to content
SAU Community

Recommended Posts

No worries, still keen to see what you can come up with for the little motor, BTW that R32GTS-t I offered you has since been sold.

Edited by Missileman
  • 2 weeks later...

Further developments. This is a Ceramic ball bearing ATR43G3SAT turbo that no longer require water cooling. Video shown turbo shaft rotation on RB25det Neo motor with engine start and shut. Super responsive.

Does that mean that you will need to idle down the car like an old truck after each drive?

Water and oil cooling has many benefits, unless the CBB is different

Just works like a normal water cooled bb unit. Except it doesnt require water cooling. Made for cars with oil cooled only turbo setups.

I will withdrawn the comment for now. It could be other causes, The bov is blowing air out, not sucking in.

You can run water to it if you want to.

Previous data shown boost curve is almost identical. but this one made more power.

Using same car with identical mods:

21U G3 high flow:

boost.jpg

ATR43G3SAT CBB

boost.JPG

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • If you are genuinely considering trying to get this engineered, I would strongly advise finding the engineer that is happy to sign that off first before you put the hole in your car.  I've seen cars get defected for this and not be able to be put back on the road as no engineer they spoke to was happy to sign if off.  
    • Apologies, while id like to put the MAF as close to the TB and relocate the recirc, this may be too much work. Will most likely end up just putting it on the original AFM spot ( onto/next to the airbox ).  Was going through nistune, found a pretty nifty doc on this. Nistune MAF Notes. Also, i was looking through the bay, and there seems to be a tube/line connected from the A/C to the intercooler piping ( Between the smic and the recirc), what does this do as the crossover fmic piping doesnt have any connection? plumbing? not sure what you call it but the nipple thing ahah.  Also, been reading up more about crossover fmic in regards to the legality of having the hole drilled for the piping, this would most likely need to be engineered right?
    • My advice is if you need a big build done do it in Japan. The yen rate is so favorable and there are shops that can be genuinely trusted and not micromanaged/carefully monitored every step of the way. Garage Yoshida is obviously my preferred option but they're so busy these days and all interaction with new customers has to be mediated through BBL/Toprank now. 
    • I haven't....but a poorly made one would terrify me. Surely a good second hand one is the go, as they don't work hard and no-one wants to keep one after they are finished with it A big consideration would be the weight of the shell you are putting on it....is it a fully dressed chassis or just the body
×
×
  • Create New...