Jump to content
SAU Community

Is This A Sticker?


Recommended Posts

iv got them on my car 2, looks like everyone has them then. However it seems like a good thing though as I can see a couple or spots that look like they have had a few stones thrown their way and the sticker has done its job and saved the paint and taken the impact. Silver paint FTW dosent stand out that much when the car is clean

Link to comment
Share on other sites

I had taken off those stickers. Was an absolute pain to get the sticky stuff off. Dunno how I got off. I used a combination of wax, clay bar, this bur/tar remover and alot of elbow grease.

Half way through taking off the sticker...I thought I shouldnt have started...but is all good now.

My echo has those stickers as well...I hadnt taken it off but there are heaps of stone chips around the sticker!

Link to comment
Share on other sites

ur lucky! haha

i'm might not have had any sticker but i've actually had other things go wrong with the V since i've bought it.

only had the V for about 5 months but have had to spend over $2k on it.

it's been good for the past couple of weeks but i'm dreading to think what will go wrong next.

Link to comment
Share on other sites

i'm might not have had any sticker but i've actually had other things go wrong with the V since i've bought it.

only had the V for about 5 months but have had to spend over $2k on it.

it's been good for the past couple of weeks but i'm dreading to think what will go wrong next.

spending 2k on FIXING it or spending to mod it? they are 2 different stories~ :laugh:

Link to comment
Share on other sites

Got them and will ask the detailer in a few weeks to remove and polish that section up to match

White cars sometimes are the worst!

Hey Matt did you get to book in Mark from Dr.Detail? what did he say about your problem?

Im removing my sticker toms!

Link to comment
Share on other sites

nah just fixing it

i would of loved to have spent that $2k on mods...fingers crossed i won't have any more problems

and while we're on the subject...

in the last 3 months....I've had 'fixed'....

Gearbox rebuild...$4000

Driver's door lock actuator $400

Fuel Flap/door motor $N/A (fixed myself from spares)

Battery $100

Passenger Power window motor $400

Clutch and Fly wheel (no, not part of the gear-box!) $1500

Brembo brake pads/rotors renewed $400

mmmmmm.......good farking thing I didn't have to pay for it!

Extended warranty really is a good thing.

Battery came out of my own pocket....fair enough.

Link to comment
Share on other sites

Hey Matt did you get to book in Mark from Dr.Detail? what did he say about your problem?

Im removing my sticker toms!

He came and saw my car. Said the white ones come up great.

He said the problem was most likly the stuff is sticking to the car alot more than others because there is so many hills and vallys in the paint. I did get it off with the clay bar, but it was a stuggle.

Once the car is detailed and smooth, should be a breeze to wash.

Mark was great to talk with and i'll be booking it in very soon.

Link to comment
Share on other sites

and while we're on the subject...

in the last 3 months....I've had 'fixed'....

Gearbox rebuild...$4000

Driver's door lock actuator $400

Fuel Flap/door motor $N/A (fixed myself from spares)

Battery $100

Passenger Power window motor $400

Clutch and Fly wheel (no, not part of the gear-box!) $1500

Brembo brake pads/rotors renewed $400

mmmmmm.......good farking thing I didn't have to pay for it!

Extended warranty really is a good thing.

Battery came out of my own pocket....fair enough.

i bought privately so had to bear all the costs myself. Should of bought from a dealer as all the problems with the car would of been covered by warranty.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • You all are absolute legends! Thank you for helping me put this into context with your comparisons!
    • There's probably an underlying issue with the A/C system too. I recently fixed mine, now it's fully control by the Haltech and car's factory HVAC controller  Have a squiz here:    
    • And by the way, I've also checked the ECU diagnostic numerous times and got a bad O2 sensor code and initially an Ignition Primary code, which is why I replaced the O2 sensor and all the ignition components (coil packa, plug and loom). No codes have been coming up lately despite the ongoing issue.
    • Hey pber13, unfortunately still no luck. At this point the following has been done with little or no success: - Spark plugs replaced, gapped to 0.8mm - Splitfire coilpacks installed to replace originals - Replaced Ignition Coil/Coilpack harness with a new genuine nissan one - New fuel filter - Replaced AFM/MAF sensor - Injectors have been thoroughly cleaned with an online flush (without removing) - Upper engine and inlet decarbed - blew tons of black smoke out, cleared the carbon deposits from the top of the engine and exhaust.  - IACV removed and thoroughly cleaned with carburettor cleaner - O2 sensor replaced with new and genuine one -  Smoke test revealed no vacuum leaks - Healthy compression test of 160psi across all 6 cylinders Overall the car does run a lot smoother now, no backfires between gear shifts like it did originally... but the rough idle when warmed up is still there. It may not even be a misfire but simply a rough idle. Seems crazy to me that so many people have had this issue and seemingly no one has gotten to the bottom of it, or at least never bothered to post if they did! Hope you have more luck than I did pber13, I'm at a point now where I'm just going to try to ignore it unless it gets worse. Would love to fix it but I've genuinely run out of ideas of what it could be.
    • I got the full frenchys kit too. Really awesome kit. Easy to install my only complaint was the hardlines I think could be routed differently (I modified mine) but I realise the kit needs to suit multiple applications. This was the hard lines before I modified them. They were touching the wastegate pipe. I ended up reducing the distance between firewall and first bend. The made it so they tucked along the frame rail.
×
×
  • Create New...