Jump to content
SAU Community

Engine/AMP Noise!

RGS

By RGS,
in Car Audio & Electrical

 Share

Recommended Posts

RGS Contributor

RGS

Posted
Posted

OK Boys I have a problem,

I just installed a Response 4ch and a Pioneer DEH-P5550MP and all is sweet until I turn the engine on a and get alternator noise....

I tried putting a Dick Smith capacitator on the alternator but it didn't work!

Pleas help - I have a six hour trip next w/end and dont want to listen to that damn whine....

Link to comment
https://www.sau.com.au/forums/topic/26285-engineamp-noise/
Share on other sites
AutoTrust Mentor

AutoTrust

Posted
Posted

Chances are that it is an amp. Skylines rarely have problems with this, also some amps will only whine on high frequencys 1st stop should be Jaycar if it's a new amp and try another. if they wont help then make them. make sure that your Rca leads are good quality and dont run too closely to electronics such as the ECU.

Link to comment
https://www.sau.com.au/forums/topic/26285-engineamp-noise/#findComment-558126
Share on other sites
RGS Contributor

RGS

Posted
  • Author
Posted

OK thats a start - I run OK RCA's but nothing flash. The amp is a Jaycar Response 4ch (New). The leads run from HU left and along the passenger side of the car into the boot where the amp is on a nice shelf next to the battery which I spent ages making. The AMP is earthed to the same -'ve terminal as the battery ie that piece of metal with two nuts attaching it to the chassis. The +'ve lead rund from the battery no longer than 1ft to the amp. All power cables are as thick as my little finger (about 1cm ish).

Suggestions?

Link to comment
https://www.sau.com.au/forums/topic/26285-engineamp-noise/#findComment-558324
Share on other sites
AutoTrust Mentor

AutoTrust

Posted
Posted

Undo your kick and scuff panels and pull the rca's away from the computer and the main wiring harness and have a listen, if it's still the same go see jay car and ask them if you can try another amp.

Link to comment
https://www.sau.com.au/forums/topic/26285-engineamp-noise/#findComment-558441
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • alburger87
      HY51 Fuga Hybrid

      By alburger87 · Posted

      True, might get it looked at. Found out you can in fact flatten the 12v battery relatively easily too the other day (kids lefts the hazards on) so meaning to get that checked in the new year. What's odd is it'll blow cold from both vents if you have the ac down as low as poss (18), but anything else the passenger one blows warmish. Also has been summer since I got it obvs but noticed it didn't seem to want to blow hot last night when we had a cold snap. 
    • Kinkstaah
      NC MX5

      By Kinkstaah · Posted

      You ask for things. You specifically state you want responsiveness. A link was provided for a far superior, more responsive option. Find a MX5 workshop that will install it for you. Maybe MX5 Mania will throw on the Fab9 kit. It seems they want to charge almost 14K installed for their kit, so if they charge you $6K to install the FAB9 kit then you'll be ahead? Though really, the 2.5 with a 2860 running low boost will more or less feel as good as anything else. It's a lot of displacement and a small turbo. Think of a more modern RB26 with one stock turbo :p TBH, truth be told I've been driving my own car, and use about 50% throttle at most for 99.9% of the time. Mr Bogan is likely similar so this is all going to be semantics for the use case he actually has. (He'll be happy with anything relative to now) However, the EFR is hands down far superior in this use case. You really, really, really, really do notice it over the Garrett or equivalent.  
    • Dose Pipe Sutututu
      NC MX5

      By Dose Pipe Sutututu · Posted

      You are correct, the earlier the torque, the earlier things snap
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Gents, it will be getting the MX5 Mania kit and the 2.5 will be staying where it is My query was about the 0.64 or the 0.86, whilst the 0.64 might spool a bit faster, would the 0.86 be better IRT EGT and mechanical sympathy, with only a small difference in spool And as I assume I won't need alot of boost to get to 200kw, probably around 10 psi, and with max rpm at 6500, would high EGT even really be a issue with a 0.64 I'm heading into MX5 Mania at the end of Jan to discuss the install, so any info is welcome prior to that Basically have a chat and book a time so they can throw on the turbo kit, and fit a oil cooler with a thermostat, drive in drive out of course  In other news: just finished cleaning the car inside and out, it's now all ready to get covered in bugs and dirt driving to Goulburn tomorrow to lunch,  and go for a stroll along woolondilly River with the daughter and her boy, and of course, visit my grandcats and my new grandpuppy 
    • GTSBoy
      HY51 Fuga Hybrid

      By GTSBoy · Posted

      Sounds like it has an actual problem with mode select doors, or something.
×
×
  • Create New...