Jump to content
SAU Community

R32 Gtr Parts

IDO 11S R32
 Share

Recommended Posts

IDO 11S R32 Collaborator

IDO 11S R32

Posted
Posted

Hi, just selling a range of parts to suit an R32 GTR, these parts were on the car which made 240awkw with this set up.

I have 2 x T25 turbos (I think)

specs of the turbos are,

M24 Garrett, 0.53 inlet and 0.48 on the exhaust side

The number on the id plate of the turbos read T702987-3

Turbos have done about 30,000k one has slight shaft movement and the other has virtually none. Both spin freely and were in perect working order when removed from car, only changed due to upgrade. I was told that these turbos are the standard item fitted to the R34GTR's. I can tell you that 240kwatw is about all you will get out of these turbos, they have vertually no lag and are very strong through the midrange, but they do run out of steem up top. By about 6000rpm in third gear I noticed the power flatten out. Car ran mid 12s with these turbos. They are a good upgrade from the standard 32/33 gtr turbos as they are steel wheel, not ceramic so they wont break.

After $400ono

.

Also have standard R32 GTR intercooler $250ono

.

Turbosmart 2 stage boost controller $80ono

.

Standard R32 GTR injectors and fuel pressure regulator. Make an offer?

Injectors need service.

.

8 x standard GTR coil packs. Make an offer?

The two extra came with the car when I bought it, the origional 6, at least one is faulty, car had a miss with these fitted, dont know if there is a way you can check to see which ones are good.

.

R32 GTR Mines tuned ECU $200ono

.

EMS ECU with wireing harness, this was piggybacked to the origional ECU in my car. This is an old model EMS but might be useful to someone,

$250ono

.

Origional GTR intercooler pipeing as shown in pics, $40

.

Apexi pod filters attached to standard air flow metres. $100

Air flow metres appear in good nick dont know how to check them and they were never functional in my car as it always ran map sensors in the time I have owned it.

.

Cusco front strut brace, $60

.

Blitz to atmosphere BOV with custom made (looks abit dodgy but works) 2in adaptor. $80ono.

.

Items are located at Minchinbury, in Sydneys west, Im a stones throw from WSID. Im happy to post the smaller items at the buyer expense, the larger ones might be too expensive but Im happy to try and get a price for you.

.

Any questions or if you are interested in anything, just give me a call,

Moray, ph: 0414 355 383

post-42702-1238936073_thumb.jpg

post-42702-1238936181_thumb.jpg

post-42702-1238936241_thumb.jpg

post-42702-1238936292_thumb.jpg

post-42702-1238936371_thumb.jpg

post-42702-1238936439_thumb.jpg

post-42702-1238936648_thumb.jpg

post-42702-1238936778_thumb.jpg

post-42702-1238936995_thumb.jpg

post-42702-1238937117_thumb.jpg

post-42702-1238937059_thumb.jpg

Link to comment
Share on other sites
bros Explorer

bros

Posted
Posted
Hi, just selling a range of parts to suit an R32 GTR, these parts were on the car which made 240awkw with this set up.

Standard R32 GTR injectors and fuel pressure regulator. Make an offer?

Injectors need service..

What are you thinking for these?

Ones in good nick go for $200ish or....

Link to comment
Share on other sites
IDO 11S R32 Collaborator

IDO 11S R32

Posted
  • Author
Posted
hi, pretty interest in boost controller

is that a Dual stage one? how about the condition, and workin order? any faulty

cheers

Boost controller was in full working order when removed from car, has since been kept wrapped and protected. SO should be in full working order, these are pretty basic items, cant imagine having any problems with them, also comes with red boost switch. The switch changes from 1st setting to second setting, so yes it is a duel stage item.

Thanks.

Link to comment
Share on other sites
  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • robbo_rb180
      What do you do with all the spares?

      By robbo_rb180 · Posted

      I did a pretty ruthless clean up before I left townsville. If it wasn't a part to suit a car I currently have it was sold or binned. I have all my stuff organised in big tubs with lids that stack from supercheap and bunnings depending on who was cheaper at the time. Parts were sorted by either chasis/motor/Fabrication/general/electrical. I have a mezzanine that's 7mx2.3m and all lives up there. Easy to access when needed and out of the way.  I also have the issue of selling and dealing with scumplace/marketbook was actually going to list stuff today but couldn't be bothered as been stuffed around too much. I generally let a few people know I want to off load stuff and people pass it on to others to contact me, generally easy sale and I'm never looking to make big dollars. Rather it gets used than go in the bin. Next clean up will be around Xmas and if doesn't go on the s15 it's going bar 2 sets of wheels. 
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      Did a little bit on the V37 today. I bought this LED kit out of the US https://www.ebay.com.au/itm/125953603618. Best I could find online but didn't look great, in the end the quality was pretty much right and it did come with locations for each light including rear number plate and a few spares. The factory owners' manual was also useful with information on where to pop each light out without damage. I prefer the LED look as I use it daily including at night and the LEDs are both brighter and the white light is easier to read with. Vanity mirror comparison, LEDs just look more modern The glove box was the only difficult one (and the only one that was previously blown.....), steps were Open glovebox 50% but not fully open Push up on bottom of the box to unclip it on both side, not screws or pins to remove Remove the top stays at an angle, right side then left, because.... Before dropping the glovebox totally, remove soft close clip on left Then, remove 7 screws to release the glovebox surround Twist the globe holder anti clock to release it from the surround In this case, the LED globe supplied was wider than factory and did not fit, so I ground down each side about 1mm then inserted it Last trick, start engine to check the LED polarity is correct, the globe only operates when the engine is running (whether the box is open or closed) I also moved the 4G booster and wifi across from the Fuga, a little frustrating as I could not find a good Accessories ACC source anywhere in the boot so I'll run a wire from the cabin next time I get a chance. Also, unlike the Fuga the external antenna wire does not quite fit between the rear windscreen and the body so I think I'll have to drill a hole in the roof to mount it. Probably not that interesting for most people so I'll just post once complete
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      Pretty sure I could do but it would need to be exported and reimported as the current import approval is race only. But in practice there are plenty of other practical reasons it can't be a road car despite their potential value these days like stripped interior looms, cage to cut out etc Nah, no mods to it other than updating the roll age to current regs. It makes about 350 (laggy) kilowatts on the N1s at 18psi which is enough to push it around the place
    • sammi_d
      SAUNSW - Cruise - Putty Road - Sunday 8th December

      By sammi_d · Posted

      This is it, folks! Our final event of the year... The big one, you all know and love - Putty Road! It goes without saying, but this is the biggest cruise in our calendar each year! A nice long drive, with a hearty pub feed at the end! Do you need much more enticing than that!?!? So make sure you wash the car, get your cameras out, block out the calendar, and get ready! We know you're all as excited as we are, so make sure you lock in the details and date below: Date: Sunday 8th December 2024 Meet Location: Corner Windsor Road and Groves Avenue McDonald's / KFC (3 Groves Avenue, Mulgrave) Meet Time: Meet at 9:00am for a 9:30am departure Destination: The Royal Hotel, Singleton (84 George St, Singleton) Map: https://tinyurl.com/saunsw-puttyrd Itinerary: We will meet at McDonald's / KFC on Windsor road and from there will head onto Putty Road. There will be a break at the Grey Gum Cafe (8679 Putty Rd, Putty) which we should reach at approximately 11:30am. For all the Newcastle folks this will be a good point to join up. From here we will continue on to Singleton for lunch. Please remember to fill up prior to heading onto Putty Road. There will not be a fuel stop until Singleton. To those running on E85, Freedom Fuel (old United) at Vineyard on Windsor Road has started selling there. At Singleton there is a range of servo's available including BP, Shell and Caltex. There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU:NSW and thus, treat others accordingly. • Any misbehaviour will not be tolerated and you will be asked to leave. Thanks guys and hope to see you there! 
    • sammi_d
      SAUNSW - Cruise - Evening Old Pac Run - Sat 23rd November

      By sammi_d · Posted

      Back by popular demand - we're lining up another Old Pac Run! Get your cars ready for one of the best night runs on the calendar! So without any ado whatsoever, here are the details for you to save: Date: Saturday 23rd November 2024 Meet Location: Cowan Truck Stop (Pacific Motorway - Refer to Map) Meet Time: Meet at 7:30pm for a 8:00pm departure Destination: Gosford McDonald's (65 Pacific Highway, Gosford West) Map: https://tinyurl.com/saunsw-oldpac Definitely an easy one for this cruise, meet at Cowan Truck Stop and jump straight onto Old Pacific Highway! Final stop at McDonald's which has plenty of parking all around. Please be mindful of the added police presence lately so best behaviour is expected! There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our track days. This is an official SAU:NSW event and will be run under a Motorsport Australia permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU:NSW and thus, treat others accordingly. • Any misbehaviour will not be tolerated and you will be asked to leave. Thanks guys and hope to see you there!
×
×
  • Create New...