Jump to content
SAU Community

Recommended Posts

Hey guys. Earlier today i was cleaning my AAC valve, using Insu's "Diy Aac Valve Cleaning & Idle Reset" guide (really good guide if your having idling issues). All was going well until i got to the part where i change the idle on the ECU. When i pulled out the ECU, i found two things odd. Firstly, there is a 'wangan' sticker on it (pictured below):

post-48960-1240286530_thumb.jpg

post-48960-1240286667_thumb.jpg

And Secondly, i dont have an electronic idle tuning screw. There is just a gap where its suppose to be.

This is what its meant to look like:

post-48960-1240287344_thumb.jpg

And this is what mine looks like:

post-48960-1240287116_thumb.jpg

Does anyone have any ideas of whats going on with my ECU???

Whats the wangan sticker about and why dont i have an electronic idle tuning screw???

Thanks, Matt.

It may be an ST Wangan modified ECU.

They are based in Malaysia and are tuned by Jun Furukawa.

The logo is different so I'm probably wrong here, but it's a very mild possibility.

At the very least it's a modified ECU that's been calibrated to your car, so don't panic.

I think it has also had the speed limiter removed and maybe rev limiter removed? seems quick for a "stock" car.

was gonna suggest a Bee R limiter mat but havent seen you in ages

and maybe a dyno run to check out the AFR's. maybe take it to Andrew Kuc when he is done with all the targa cars.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Hi    have purchased pair of eibach wheel spacer as I couldn’t fit set of wheels I bought for my car due to it catching caliper.   I know I need to cut the bolts on my discs so they sit flush with the nut supplied but the nut doesn’t sit all the way into the groove meaning wheel would not directly fit onto the spacer rather the nuts. Any thoughts?   See pic   https://ibb.co/VJK5w5G
    • Nah. There's not shit tonnes of pressure in there. Just drill with a 1.5mm drill or something equally tiny. When the drill goes all the way through thee gas will start to come out, but with such tiny path through the flutes of the drill bit, it won't be at all dangerous. You can be as paranoid as you like from then on. I'd just pull the drill out while keeping my face out of the line of fire. But then, I spend half my time looking into pressurised furnaces. So my risk acceptance is somewhat higher than most!
    • Been needing a new clutch for a while, but holding off because of life tingz and adulting. But... Being of Asian descent, I can't pass on a good sale, especially everyone else is selling it for $2k+ (JJR has it for $1799). Really on the fence on this one, because the unsprung version of this is $1281 via Shitbox (Sparesbox) and the sprung version is quite a bit more (no idea why Shitbox doesn't offer them). Ending up just sending it and getting the twin sprung organic. Mainly because I wanted the car to be nice to drive and didn't want to make it more of a shitbox than it already is.    
    • It was the pressure I was worried about. @GTSBoy does drilling them pose any problems?
    • yep just a JIC vs ISO insulator height. old coils are for JIC, new coils are for ISO
×
×
  • Create New...