Car Alarm Central Locking Wiring

[Pete82]

Hello,

Im in the process of wiring up an Cyclops alarm with central locking output.

This alarm gives a seperate negative pulse for the lock and unlock signal.

ive worked out which wire i connect to for the unlock, however im not sure how to get it to lock?

which wire/wires do i need to use to get it to lock?

Any help will be most grateful.

Has anyone been able to keep the factory alarm system working off an aftermarket alarm remote?

Thanks

[Chris Rogers]

did you sort this?

[Pete82]

Hello Chris,

Yes i did end up fixing this, thanks for your help.

Once i connected the yellow wire to the purple one to get the central locking to active all together, there are 2 wires from the door lock switch which i used to trigger the lock and unlock pulses rather than using the single negative to unlock, open to lock.

Cheers

Pete

[Chris Rogers]

ok yours is an early car. the later ones are different.

[Pete82]

How do you remove the factory alarm,

do you just need to undo each scotch lock, and removal all the wires, there are ultrasonic sensors on the dash, and this control module that runs off the central locking obviously to arm/disarm the alarm?

There is also the siren mounted under the glove box.

Thanks

[Chris Rogers]

the japs put it in there - reverse engineer it