Jump to content
SAU Community

Recommended Posts

Hi all,

Currently trying to get the oil filter of cheff stageas wags for him and it seems as if theirs a bracked or something on the side/next to it that stops it from comming loose?

Is this correct if so whats the go with removing it to change the oilfilter?

Its a stock setup no filter relocation kit or anything :(

Fast replys would be good :banana:

Cheers,

Chris

Sounds like the oil pressure switch is in the way? With rb26's you pretty much need to attack the oil filter from underneath with a oil filter wrench or another type of oil filter remover, normal oil filter removers you would normally use on a commodore just aren't very effective.

Sounds like the oil pressure switch is in the way? With rb26's you pretty much need to attack the oil filter from underneath with a oil filter wrench or another type of oil filter remover, normal oil filter removers you would normally use on a commodore just aren't very effective.

How? The transfer case or front diff is below the oil filter on RB26's, there is nearly no room to go in there from underneath.

I had several people attempt to remove my oil filter, tried a few oil filter wrenches and removal tools, eventually a very strong mechanic just put his hand in there and was able to remove it >_<

Hopefully your one hasn't been done up super tight...

last two I have removed, it was a long screwdriver, through one side out the other and use that to get it started..

made a hell of a mess.. almost thought i had broken my hand trying to get the bastard undone..

next time will be the last, relocation kit incoming.

to undo it properly you need the three pointed claw type attachment that grips onto the end of the filter.

I do mine all the time - pop on some rubber gloves for non slip grip and remove it; also stops your hands gettin thrust against sharp objects in the engine bay lolz

try a filter like knn with a nut on the top so you can remove it with a ratchet next time.

If you have one of those stock Nissan/Pitwork filters on there then the screw driver trick won't work lol as it does stick out far enough, we tried a belt, to no evail, we also tried my very strong mate who couldn't get it off, we ended up getting a 1/2 inch drive oil filter wrench that combined with my strong mate was able to finally wind it off. the oil filter was half twisted around so it must have been on pretty tight. However there is a relocator in place now so i will have no more dramas like that

Did it come like that from Japan? I had a super small filter (not a Z143A, same thread about less than 1/2 the size, made it more challenging) and it had a metal exterior that got damaged by the time it was out....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...