Looking For 'pig Tail' Injectors For My Turbo L24

[noddle]

Hi,

I'm in search for injectors (low impedance) for my N/A Turboed L24, the ones I'm running don't flow enough (RB30 200cc)

I need the 'pigtail' type (hose type, not O ring)

maybe something around 350-400cc

so if anyone know what these may come off, so I have a idea what to look for

Nigel

Edited May 25, 2009 by noddle

[Ghostrider]

L28et are 265cc or FJ20et are 375cc.

Personally I'm going to use FJ20et in my L28et in my PNV, because I'm going a bit ballistic with the new DR30 acquisition.

Cheers, D

[OUTATIME]

rb30et 260cc, rb20det redtop 260cc, ca18det 360cc (i think) rb26dett 440cc (o ring but can jam a hose on the end of em)

[Factory 5]

ive seen the hose on the o-ring mod, its not too hard,

best to tape the injector all over, then cut where you want to be 'barbed',

make 2 mm rings along the shaft

then force the hose on (heating up in tin of boiling water helps soften it up)

use clamps carefully, best ones are the original type ones that clip, not screw in to tighten

[Ghostrider]

I have a set of 460cc O'Ring type Hi Imp RX7 injectors, including plugs if your interested, just need to use a VL resistor pack with them.

Also a set of 7 x 550cc O'Ring type Low Imp RX7 injectors.

Price will/could be very affordable.

Cheers, D

[noddle]

I have a set of 460cc O'Ring type Hi Imp RX7 injectors, including plugs if your interested, just need to use a VL resistor pack with them.

Also a set of 7 x 550cc O'Ring type Low Imp RX7 injectors.

Price will/could be very affordable.

Cheers, D

I sent you a PM,

Nigel

[Ghostrider]

I'll reply by email tomorrow night with some luck.

Picking up the DR tomorrow afternoon, hey hey!

Cheers, D