Advice Please

[JAV360]

Hey there as topic description states, how do you remove the ignition barrell from series 1 stageas?

all help appreciated.

Jarrad.

[SLEEPR85]

...... so your stealing one then?

[JAV360]

...... so your stealing one then?

Ha, na I have a wrecked one and someone needs one due to there's being damaged.

[kidafa]

i will back up jav he has two stags.. one wrecking cos of some idiot commo driver

ps jarrad check ur pms i sent u one last week no reply where is the love?

[M I K E]

i assume you're looking at how to get it off becuase it has the dome topped bolts holding it in? all you need to do is get a dremel with a thinnish cutting blade on it and cut a slot in the top of them so you can undo them with a screwdriver

[kidafa]

Mike still got that wing? it wont let me pm u for some reason

[JAV360]

thanks mike, managed to drill those shear bolts and use an easy out to wind out.

just wondering how the ignition barrell comes out of the casing?

Anyone know?

[lachlanw]

having pulled apart a few ( but not a stagea one ) i would say it has roll pins pushed into holes that dont go the whole way through . either put small screws in them and pull them out or drill holes (its only poos alloy ) and push them through .

[STAGWAGN]

Well it just so happens that one of us is a locksmith You will notice that there is a plug/pin pressed into the side of the ignition housing... well what you need to do is drill beside that pin and using a sharp centre punch tap with a hammer and lever upwards on the pin at the same time.Doing it this way you will be able to reuse the hole and the pin as opposed to drilling the pin. Some of the nissan ignitions have multiple pins so you will need to use this method for each pin. When they are all removed the ignition cylinder will just slide out of the housing.