Jump to content
SAU Community

Recommended Posts

Time for a big clean out! Stuff at low prices!

Pickup can be arranged from northern suburbs VIC or Melbourne CBD

Quantity is shown in brackets. i.e. (2) means i have 2.

Prices are per item, and exclude postage unless otherwise stated.

All items are used in good working order unless otherwise stated.

Offers by PM please

Pics coming soon!

:thumbsup:

SR20 Turbo Inlet Elbow (1) - $20

SR20 Coil Pack LoomsSR20 (5) - $20

SR20DET AirboxSR20 (1) - missing one clip, small round hole has been melted into it presumably for some kind of mod - $40

CA18DET water pump (1) very good condition - $20

CA18DET Idler Pulley (1) - Brand new - $100

CA18 Turbo Inlet Elbow - $20

CA18DET AFM -> Turbo induction pipes (2) - stock rubber pipe - $10

CA18 Wastegate actuator (1) - $20

CA18DET Tensioner Bearing (1) - Brand new - $90

S13 analogue climate control units (2) - one has sticky buttons but could be cleaned up - $20

S13 cooler intake crossover pipes (see pics when they're up) - plastic stock items for silvia and 180SX - $20

S13 Centre Aircon Vents (1) - Brand new in box - $90

[0b]R32 GTST M front bar [/b](1) in silver, intact with a few scrapes and dents (as pictured) - $20

R32/S13 Castor/Tension Rod (1) - stock - $20

R32 coolant overflow tank (1) - Fine apart from tiny (drip) leak in bottom, could be sealed without much hassle - $20

R32 power steering reservoir (1) - from R32 with HICAS. no leaks. fine other than wires from cap broken off but still have it with the plug (for level sensor) - $20

R32 GTST rotors (front pair) - both ~27mm - $40

RB20 TPS (1) - $40

RB20DE AFM -> Turbo induction pipe (1) - stock rubber pipe - $10

RB20 Turbo Inlet Elbow (1) - $20

RB20 S1 Coil Pack Loom (1) - half plugs cracked. good if you need to replace a cracked one or 2 on your own loom - $5

RB20 S2 Coil Pack Loom (1) - All good except for #1 connector missing. wiring is there though. - $20

RB20DET Exhaust heat shield (1) - $10

RB20DET motor with polished & embossed CAM gear cover - was complete when i bought it but have since pulled a few parts off it.- $250ono

So engine excludes the exhaust side, ps pump, alternator, A/C compressor, AAC, TPS, injectors & rail, coil packs).

RB25 Airbox Snorkel (1) - A rare find!! - $40

RB25 Crank (1) Had been straightened not long before the motor was pulled down - $100

RB25 block (1). Some damage to cylinder walls. Might be ok with a bore/hone? - $20

RB25 Stock oil cooler (1) - $15

RB25 Turbo oil out/drain pipe (1) - $15

RB25 Water pump - used but not for long before engine failure - $20

RB25 S1 Coil Pack Looms - (3) - $25

RB25 S2 Coil Pack Looms -(2) - $25

RB25 wastegate actuator (1)- $20

RB25 AFM -> Turbo induction pipes (3) - stock rubber pipes, unsure exactly which model they're come from (see pics when they're up) - $10

R33 GTST rotors (rear pair) - both ~18mm - $40

RB coilpacks (6). From an RB25. Were replaced with spitfires due to miss under high boost. - $20

RB26 Rods (6) + forged RB25 pistons (6). Pistons are damaged - unsure if salvageable? - $250 the lot

RB26 stock fuel rail & reg (1) - $70

Z32 Complete airboxes (2) - $50 each

Aftermarket Gearknob (1) Red with fake CF - $5

External fuel pump brackets (3) - aftermarket and brand new - $10

  • 4 months later...
  • 7 months later...

i'll take the water pump for the rb25 if its in good nik..when can i pick it up? lemme know...gimme me a call or txt. 0411795674 cheers

Edited by ZaLaZaNe

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Holy smokes brother. If you get there before me, let me know if that was manageable with a hone. I still haven't done anything with mine and probably won't until I get the car MOT'd later this year so that I have another 2 years to do what ever needs to be done. I am at 86.5 now so at least I have the 0.5mm to go up from where I am, but that means new pistons at the very least. Honestly, might consider a stroker at that point.  Cheers
    • It's the adhesive holding the ceramic wheel to the shaft the fails on 90% of them.
    • Foreign debris, physical shock, boost leak, could be anything honestly. The danger in taking all the timing out of a tune/hitting the R&R corner is that even if the engine doesn't detonate your turbo is taking a lot of abuse from high EGT. Also, even if nothing goes wrong it is a journal bearing that is spinning at 100k RPM on boost. Eventually it goes through enough cold start/pressure cycles to wear it out.
    • I kinda accidentally saw this, and was interested, but It actually seems to replaces the whole center computer, using the existing screen and buttons. AND it may only be for a G37 and not compatible with a Japanese 370. So its not for me, but someone else may be interested to look into it. Its about $680USD. If I am understanding it right, it basically replaces/installs and android pc that integrates with the existing screen. But I could be wrong. https://gromaudio.com/vline/ The video I first saw was the following, with very little and unclear details.     Even if your not interested in the system, the video on their site was pretty comforting in showing how simple the whole centre comes out
    • hfygrte52 what side you looking for? Do you care what color car it's off? Found a white LH side on here: https://skylinespares.com.au/product/nissan-skyline-r33-coupe-rear-tail-light/   Aussie parts place but will ship to USA. Maybe get it before there's a tarrif on 25yo shit box parts
×
×
  • Create New...