Time To Clear Out! It's The Parts Or Me :)

[46n2]

Time for a big clean out! Stuff at low prices!

Pickup can be arranged from northern suburbs VIC or Melbourne CBD

Quantity is shown in brackets. i.e. (2) means i have 2.

Prices are per item, and exclude postage unless otherwise stated.

All items are used in good working order unless otherwise stated.

Offers by PM please

Pics coming soon!

SR20 Turbo Inlet Elbow (1) - $20

SR20 Coil Pack LoomsSR20 (5) - $20

SR20DET AirboxSR20 (1) - missing one clip, small round hole has been melted into it presumably for some kind of mod - $40

CA18DET water pump (1) very good condition - $20

CA18DET Idler Pulley (1) - Brand new - $100

CA18 Turbo Inlet Elbow - $20

CA18DET AFM -> Turbo induction pipes (2) - stock rubber pipe - $10

CA18 Wastegate actuator (1) - $20

CA18DET Tensioner Bearing (1) - Brand new - $90

S13 analogue climate control units (2) - one has sticky buttons but could be cleaned up - $20

S13 cooler intake crossover pipes (see pics when they're up) - plastic stock items for silvia and 180SX - $20

S13 Centre Aircon Vents (1) - Brand new in box - $90

[0b]R32 GTST M front bar [/b](1) in silver, intact with a few scrapes and dents (as pictured) - $20

R32/S13 Castor/Tension Rod (1) - stock - $20

R32 coolant overflow tank (1) - Fine apart from tiny (drip) leak in bottom, could be sealed without much hassle - $20

R32 power steering reservoir (1) - from R32 with HICAS. no leaks. fine other than wires from cap broken off but still have it with the plug (for level sensor) - $20

R32 GTST rotors (front pair) - both ~27mm - $40

RB20 TPS (1) - $40

RB20DE AFM -> Turbo induction pipe (1) - stock rubber pipe - $10

RB20 Turbo Inlet Elbow (1) - $20

RB20 S1 Coil Pack Loom (1) - half plugs cracked. good if you need to replace a cracked one or 2 on your own loom - $5

RB20 S2 Coil Pack Loom (1) - All good except for #1 connector missing. wiring is there though. - $20

RB20DET Exhaust heat shield (1) - $10

RB20DET motor with polished & embossed CAM gear cover - was complete when i bought it but have since pulled a few parts off it.- $250ono

So engine excludes the exhaust side, ps pump, alternator, A/C compressor, AAC, TPS, injectors & rail, coil packs).

RB25 Airbox Snorkel (1) - A rare find!! - $40

RB25 Crank (1) Had been straightened not long before the motor was pulled down - $100

RB25 block (1). Some damage to cylinder walls. Might be ok with a bore/hone? - $20

RB25 Stock oil cooler (1) - $15

RB25 Turbo oil out/drain pipe (1) - $15

RB25 Water pump - used but not for long before engine failure - $20

RB25 S1 Coil Pack Looms - (3) - $25

RB25 S2 Coil Pack Looms -(2) - $25

RB25 wastegate actuator (1)- $20

RB25 AFM -> Turbo induction pipes (3) - stock rubber pipes, unsure exactly which model they're come from (see pics when they're up) - $10

R33 GTST rotors (rear pair) - both ~18mm - $40

RB coilpacks (6). From an RB25. Were replaced with spitfires due to miss under high boost. - $20

RB26 Rods (6) + forged RB25 pistons (6). Pistons are damaged - unsure if salvageable? - $250 the lot

RB26 stock fuel rail & reg (1) - $70

Z32 Complete airboxes (2) - $50 each

Aftermarket Gearknob (1) Red with fake CF - $5

External fuel pump brackets (3) - aftermarket and brand new - $10

[TRB-001]

dont have any ac vents for a r32 do ya? dibs if u do?

or a r33 gtst turbo? with lines??

[SIK 31S]

hey mate u wouldnt happen to have a digital climate control for S13??? with loom..

thanks

[46n2]

TRB-001: Sorry don't have either.

SIK 31S: Only have 2x analogue head units

Located in Epping VIC

[46n2]

RB26 Rail has no FPR, price drop $40

Pics as promised

[46n2]

bump

[rob_mr1200]

hey do u have the wirin harness that goes from the ignitor box to the cpu?

[46n2]

Sorry Rob, don't have any full engine looms, just the igniter -> coilpacks

[rob_mr1200]

damit....

thanx anyway, all i need it the plug and a lil bit of wire to go in to the plug.

[46n2]

no probs, good luck

[dwest]

I will take the piston rod lot if you send me your paypal info. Pm me or email me at [email protected]

Thanks

[namso786]

willing to post?

[iseekool]

PM sent regarding oil cooler.

[ZaLaZaNe]

i'll take the water pump for the rb25 if its in good nik..when can i pick it up? lemme know...gimme me a call or txt. 0411795674 cheers

Edited June 24, 2010 by ZaLaZaNe

[shibby69]

do you have the r33 turbo elbow?