Jump to content
SAU Community

Recommended Posts

Noticed a bit of a problem with my car last night, and its been doing it a bit this morning. Basically with a constant very low throttle applied, the car appears a little stuttery...not massively, but i can feel something.

Its a bit hard to explain, but its basically feeling a little lumpy and not otherwise as smooth as it should be around 2500rpm and 5-10% THR (on my S-AFC) just cruising around at 60km/hr or so. On heavier acceleration its fine, at idle its pretty much fine, and if i foot to the floor it, it goes at its usual rocket pace with no problems. Its almost the is like a "gurgle" or choke in the exhaust - the sort of thing you get before a backfire.

So any suggestions?

Could it be timing?

Could it be a vacuum leak (doubt it, checked all that, building up boost fine)

Could it be S-AFC settings running to rich or something? (hasn't been tuned since my new 910 fuel pump)

Could it be spark plugs? although these were only changed around 5-8k ago

Could it be something like my accelerator cable? I do notice there is a bit of slack on it. Is that normal?

Link to comment
https://www.sau.com.au/forums/topic/27375-problem-on-light-throttle/
Share on other sites

my first guess would be that ur safc might be tuned a little rich on lower rpms

mine was like that, was a little sluggish and felt like it wanted to go but couldnt till i hit boost

a tune fixed it right up, also fixed up the loss of pressure between gears somehow

try that first then go from there

remember ur car hasnt been tuned in a while and should be retuned every 2-3 months if it only has a safc

S-AFC helps a lot of things ;) although it will be less useful on a GTS, it may help it run a little smoother.

Think it could have been a bit of dodgy fuel (Caltex Gold out country way.. is that only 94RON ? ), seems to be running a lot better today, and i've still only got fairly low octane stuff in there. Its tuned for 98RON and hard use, probably a good idea to get it back on the dyno like Kami was saying and get it retuned.

I also tightened/checked all the vacuum points, so it may have been that too.

I too get some splutter low down, under medium throttle. Im putting it down to my SAFC settings. It was only ever tuned on full throttle. So when i get some time (very soon) im hiring a dyno for an hour, ($50) and going to try and squeeze a little more out of her plus do some lighter throttle testings.

You raise an interesting point. That is the big problem with dyno tuning I think. A lot of it is just done to get the highest peak power reading, which isn't necessarily good for daily driving (or in fact most driving, even on the strip or track). Some tuners are more realistic and realise you're not going to be running at full boost all the time, and tune for more across the range.

I am a believer that dyno tuning is useful to sort some things out, but it also needs a good road tune as well to tidy things up. After all, you drive on the road, not a dyno!

I asked about the low throttle settings and they said nah they are ok. I noticed at light throttle the A/F ratio was 14.2 whilst on the dyno. To me this is still rich. I think 14.7 is optimum on light throttle.

Anyway, i will throw it on a dyno and do the changes myself, may pick up some economy too.;)

guys i *always* get mine tuned on the road as it is just more realistic

also i get mine tuned on bout 1/3 - 1/2 throttle

it boosts up so much better - and i still get full boost

there is no need for full throttle imho

btw gordo if u want it retuned for the street it will cost ya bout $20 ;)

but melb is about 9% difference in the way that the environment is compared to here

still a tune up here should be good for down there too :)

Originally posted by predator666

Noticed a bit of a problem with my car last night, and its been doing it a bit this morning. Basically with a constant very low throttle applied, the car appears a little stuttery...not massively, but i can feel something.

Its a bit hard to explain, but its basically feeling a little lumpy and not otherwise as smooth as it should be around 2500rpm and 5-10% THR (on my S-AFC) just cruising around at 60km/hr or so. On heavier acceleration its fine, at idle its pretty much fine, and if i foot to the floor it, it goes at its usual rocket pace with no problems. Its almost the is like a "gurgle" or choke in the exhaust - the sort of thing you get before a backfire.  

So any suggestions?  

Could it be timing?

Could it be a vacuum leak (doubt it, checked all that, building up boost fine)

Could it be S-AFC settings running to rich or something? (hasn't been tuned since my new 910 fuel pump)

Could it be spark plugs? although these were only changed around 5-8k ago

Could it be something like my accelerator cable? I do notice there is a bit of slack on it. Is that normal?

Well there,I have exactly the same problem and my mechanic thinks I am wierd. I just had my standard fuel pump replaced with a 800 horsepower bosch unit, and its doing what yours does. More so when its cold. They put the car on dyno when warm and they said all the mixtures are fine etc. New plugs, cleaned injectors, cleaned fuel lines, new fuel filter, cleaned fuel rail, cant be the fuel system. I am taking it in wednesday night, returning thursday morning and taking them for a drive to show them so they dont think I'm mad. Some others here have advised they check the throttle position etc and see if that helps.

I'll let you know how it goes.

Paul

Dont bother setting any low throttle mapping on the SAFC. The ECU simply relearns around it to maintain the stoich AFRs. Trust me i've tried... You can even wind in 30% richer at a cruising rpm and within 10 seconds its back to stoich AFR by looking at the o2 output...

I reckon you should get your injectors etc checked out first. Just leave the low thr map empty.

The ECU runs closed loop all the time, except for when you got your foot flat to the floor above ~3000rpm. Its constantly recorrecting its sensor parameters to stay at stoich AFR so by trying to fool it with the SAFC inside of closed loop operation is futile.

You shouldnt need an aftermarket comp to fix these problems. Its most likely a vacuum leak, very dirty throttle body, clogged PVC, leaky pipes, malfunctioning EGR/Canister control, plugs etc etc. The list could go on. I suggest you get ur hands on a workshop manual and try and diagnose a few things...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I havent bought a manual cover for the dash yet and no cluster change, won't bother me too much, I just need to get that auto box gone, manual in! I miss my manual. 🤪. We started last weekend and managed to get the box out. Planning to start putting it in this weekend and then order a single piece tail. We were super careful to take time and not damage anything. It's my first time working under the car.  With my S15 mainly worked in the bay. This time, it was a headache because of three or four bolts only. They simply didnt want to leave thei homr and the one securing the tailshaft, another above the GB, and the one securing the lipstick was a shit. Mates mate, Davo caught fire 🤣, nearly opened his chest up with a grinder 🤦🏽‍♂️ and both mates nearly had a plate from the box land and slit their head open. Fun times. We all survived. Not the easiest working with limited access on jackstands. As I'm sure we can agree these are the memories which make us love our car. For all three of us, was an awesome weekend and Sunday 3.30am before tools down was a fantastic effort. I need to upload pics, but looks like it needs to be via Url now. We used to be able to just upload pics back in the day. It's been that long! 🤪 Im currently spraying rustoleum under body, not because it's rusted. It's super clean, but just so it's protected for the next 10 years. There was a few surface rust spots. Which pretty much wiped off with a 3M scourer.  Really impressed with how well the previous owner maintained it. Bank account went down so quick! Service, then GB - managed to get a spanking new 34 genuine box from Nissan. All the rest of the conversion parts from Kudos.  Went with a Nismo short shifter. New pedals and Exedy Clutch and FW. Ordered the Prp Rear Main Retainer kit which should arrive Friday and my first engine mod part just like I did with my S15 will be the Tomei Expreme Turbo Outlet. Already on order. It'll likely sleep next to me on a pillow during the coming months. 🥰 Last build was on my JET200GT profile and on SAU and Hardtuned I had documented the build. Planning to try to do that again. Brands feel scarce now. Wish we still had ARC and Apexi parts readily available. Exhaust - need some advice on this. I had an Apexi exhaust on the S15 and loved the tone. My mate had a HKS HP Silent on his 33 and suggested I go with that to avoid drone. I can't remember hearing an RB25DET running that so will likely need to wait for a meet or something to hear it.  Not after big power, just enjoy building it, and drivability with minimal negative attention.
    • Have a chat with Ben at Moore Performance or Jesse at JS Performance.
    • Thanks both. All good advice. Reminds me of drilling through stone wall for drainage pipe 😬 I'll let you know how I get on if I still have use of my hands afterwards 😅
    • Finally got shipping number for the intake and throttle body, shipped by UPS, so "should" be in my hands sometime next week, fingers fracking crossed
    • I'm so far behind in the jobs I have to do at both work and home (including car) that I have become immortal. There's simply no way that I can die now.
×
×
  • Create New...