Jump to content
SAU Community

Recommended Posts

Noticed a bit of a problem with my car last night, and its been doing it a bit this morning. Basically with a constant very low throttle applied, the car appears a little stuttery...not massively, but i can feel something.

Its a bit hard to explain, but its basically feeling a little lumpy and not otherwise as smooth as it should be around 2500rpm and 5-10% THR (on my S-AFC) just cruising around at 60km/hr or so. On heavier acceleration its fine, at idle its pretty much fine, and if i foot to the floor it, it goes at its usual rocket pace with no problems. Its almost the is like a "gurgle" or choke in the exhaust - the sort of thing you get before a backfire.

So any suggestions?

Could it be timing?

Could it be a vacuum leak (doubt it, checked all that, building up boost fine)

Could it be S-AFC settings running to rich or something? (hasn't been tuned since my new 910 fuel pump)

Could it be spark plugs? although these were only changed around 5-8k ago

Could it be something like my accelerator cable? I do notice there is a bit of slack on it. Is that normal?

Link to comment
https://www.sau.com.au/forums/topic/27375-problem-on-light-throttle/
Share on other sites

my first guess would be that ur safc might be tuned a little rich on lower rpms

mine was like that, was a little sluggish and felt like it wanted to go but couldnt till i hit boost

a tune fixed it right up, also fixed up the loss of pressure between gears somehow

try that first then go from there

remember ur car hasnt been tuned in a while and should be retuned every 2-3 months if it only has a safc

S-AFC helps a lot of things ;) although it will be less useful on a GTS, it may help it run a little smoother.

Think it could have been a bit of dodgy fuel (Caltex Gold out country way.. is that only 94RON ? ), seems to be running a lot better today, and i've still only got fairly low octane stuff in there. Its tuned for 98RON and hard use, probably a good idea to get it back on the dyno like Kami was saying and get it retuned.

I also tightened/checked all the vacuum points, so it may have been that too.

I too get some splutter low down, under medium throttle. Im putting it down to my SAFC settings. It was only ever tuned on full throttle. So when i get some time (very soon) im hiring a dyno for an hour, ($50) and going to try and squeeze a little more out of her plus do some lighter throttle testings.

You raise an interesting point. That is the big problem with dyno tuning I think. A lot of it is just done to get the highest peak power reading, which isn't necessarily good for daily driving (or in fact most driving, even on the strip or track). Some tuners are more realistic and realise you're not going to be running at full boost all the time, and tune for more across the range.

I am a believer that dyno tuning is useful to sort some things out, but it also needs a good road tune as well to tidy things up. After all, you drive on the road, not a dyno!

I asked about the low throttle settings and they said nah they are ok. I noticed at light throttle the A/F ratio was 14.2 whilst on the dyno. To me this is still rich. I think 14.7 is optimum on light throttle.

Anyway, i will throw it on a dyno and do the changes myself, may pick up some economy too.;)

guys i *always* get mine tuned on the road as it is just more realistic

also i get mine tuned on bout 1/3 - 1/2 throttle

it boosts up so much better - and i still get full boost

there is no need for full throttle imho

btw gordo if u want it retuned for the street it will cost ya bout $20 ;)

but melb is about 9% difference in the way that the environment is compared to here

still a tune up here should be good for down there too :)

Originally posted by predator666

Noticed a bit of a problem with my car last night, and its been doing it a bit this morning. Basically with a constant very low throttle applied, the car appears a little stuttery...not massively, but i can feel something.

Its a bit hard to explain, but its basically feeling a little lumpy and not otherwise as smooth as it should be around 2500rpm and 5-10% THR (on my S-AFC) just cruising around at 60km/hr or so. On heavier acceleration its fine, at idle its pretty much fine, and if i foot to the floor it, it goes at its usual rocket pace with no problems. Its almost the is like a "gurgle" or choke in the exhaust - the sort of thing you get before a backfire.  

So any suggestions?  

Could it be timing?

Could it be a vacuum leak (doubt it, checked all that, building up boost fine)

Could it be S-AFC settings running to rich or something? (hasn't been tuned since my new 910 fuel pump)

Could it be spark plugs? although these were only changed around 5-8k ago

Could it be something like my accelerator cable? I do notice there is a bit of slack on it. Is that normal?

Well there,I have exactly the same problem and my mechanic thinks I am wierd. I just had my standard fuel pump replaced with a 800 horsepower bosch unit, and its doing what yours does. More so when its cold. They put the car on dyno when warm and they said all the mixtures are fine etc. New plugs, cleaned injectors, cleaned fuel lines, new fuel filter, cleaned fuel rail, cant be the fuel system. I am taking it in wednesday night, returning thursday morning and taking them for a drive to show them so they dont think I'm mad. Some others here have advised they check the throttle position etc and see if that helps.

I'll let you know how it goes.

Paul

Dont bother setting any low throttle mapping on the SAFC. The ECU simply relearns around it to maintain the stoich AFRs. Trust me i've tried... You can even wind in 30% richer at a cruising rpm and within 10 seconds its back to stoich AFR by looking at the o2 output...

I reckon you should get your injectors etc checked out first. Just leave the low thr map empty.

The ECU runs closed loop all the time, except for when you got your foot flat to the floor above ~3000rpm. Its constantly recorrecting its sensor parameters to stay at stoich AFR so by trying to fool it with the SAFC inside of closed loop operation is futile.

You shouldnt need an aftermarket comp to fix these problems. Its most likely a vacuum leak, very dirty throttle body, clogged PVC, leaky pipes, malfunctioning EGR/Canister control, plugs etc etc. The list could go on. I suggest you get ur hands on a workshop manual and try and diagnose a few things...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm so far behind in the jobs I have to do at both work and home (including car) that I have become immortal. There's simply no way that I can die now.
    • Each to their own I guess  Me, I put just as much time into cleaning inside of the cars as I do on the outside As for getting wet, it is really no different than steam cleaning the carpets at home, apart from the cars carpet dries alot faster than the house, again, I only do it in the hotter months and leave the car opened up for a few hours As I only do it yearly, it is just before I do the diff and gearbox service, so I clean the carpets, then it's up on stands, wheels off, service, clean the undercarriage,  grease the bushings and do a nut and bolt check on everything  Disclaimer: I typically had all the time in the world to kill when I was working 馃ぃ, so spending a full day or 2 cleaning, serving and "looking at stuff" was,  easily achievable, and a fun mental therapy day As for time to kill, I retired last Wednesday, so apart from my physical training, my days are filled with lots of random jobs around the house and garden...."Idle hands are the Devils something something" I am also buying a new house sooner rather than later, I'm actually looking at a potential property tomorrow, I'm looking forward to getting a car hoist as I'm starting to get to old to crawl around under a car, I can only imagine all the undercarriage cleaning and looking at stuff when that gets set up
    • Yeah, I'm not interested in wetting the carpets, and I don't care about brown dirt/dust that lives deep in the pile or underneath. It's not like I crawl around on them in my birthday suit or eat dropped food off them (because there is never any open food in my car). The seats are alcantara (cheap Chinese imitation alcantara, to be sure!) with barely 1" of foam pad behind the surface. That's not getting wet either. Any car that I would be happy to get the interior wet, I would not care to put the effort into.
    • We have one that holds 2.8L of water. On floor carpet that hasn't been touched in 2 or 3 years, will take a minimum of 2 fills of the tank to do a bedroom, and that's going AROUND the bed.   In the cruiser, I used an ENTIRE 2.8L tank, just on the front passenger footwell. But it had some fungus growing, and had been full of mud from being used as a 4WD for many years. I can do that floor again, and it will still pull mud out. However, the water now only looks dirty, not pitch black and leaving full sludge in the bottom of the tank it sucks back into. Oh, and, this is about a $1500 unit.
    • This is mine, works a treat for the cars, suction is good, I use the Bissell clean and protect stuff I have found giving it a good spray and light scrub with the soft brush on the head of the nossle for carpet, and a rub with a microfibre for cloth seats and cloth door trims, prior to another quick spray before vacuuming it up works the best @GTSBoy You would surprised on what it gets out of carpet and seats that actually "look" clean, I recommend that you test drive yours when you have a little time to kill, then post pics of the muddy looking water that I believe you will find
  • Create New...