Jump to content
SAU Community

Recommended Posts

R33 with 3582r (i will check housing size 2moro for you) 18psi but with 264 cams.

Fuel reg on a r33 is good for high 300rwkw so your reg is not the issue.

post-34927-1245240645_thumb.jpg

Edited by URAS

Yeah, thanks for that. Doesnt matter what gear youre running , it all comes down to a proper tune doesn't it? Funny thing is this guy has one of the best reputations in Melbourne and the results to prove it, but i highly doubt that he tuned my car. Anyway i will post both dynos once i get it retuned elsewhere.

It's put in 4th gear so the tuner is able to tune it.

For example, you would not be able to tune a car in 1st gear because power just comes on way too quick.

Yes it does matter what gear you're in, 1st and 2nd gear will have much different power graphs compared to 4th gear.

Take it to another tuner to get a second opinion. Maybe something was wrong with the car (i.e. detonation) so the tuner had to pull timing out of it, hence the low power?

Maybe there's carbon build up in your engine causing pinging, or a hot spot on the piston.

Take it to another tuner, if he tells you he couldn't pull anything more than 250rwkw without it pinging of its tits, then somethings wrong with your car.

The fun and games begin.

Yeah thats exactly what im going to do. He said everything was fine, that there werent any issues and was actually quite happy. Its not that i want more power, cause its fine the way it is. Its just that i believe that with this set up (barring any issues such as the ones you mentioned) the car should have pulled more than it did. As i said i really got the impression it was done in rush to get the car out of there, and im sure it wasnt tuned by Mark himself.. I'll be booking it in this week sometime elsewhere..just for peace of mind!

got same setup, apart from I got the 0.82 A/R. I have a VERY conservative tune (f#$k all timing, and running rich, knock doesnt go over 15) and I made 312 rwkw at 17 PSI.

I suggest you go see another tuner.

the 0.82 makes 300 easy the 0.63 does not.

Edited by URAS

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...