Jump to content
SAU Community

What Is This Cable For?

omega36

By omega36,
in General Maintenance

 Share

Recommended Posts

omega36 Proficient

omega36

Posted
Posted

Hey guys.

Was just poking around in my boot and came across this unplugged cable. Not sure if it's standard or not - but where should it go? I have an outstanding 4WD circuit-related issue which I'm trying to figure out, and not sure if this may play a part.

cable.jpg

Thanks for your help!

Link to comment
https://www.sau.com.au/forums/topic/277437-what-is-this-cable-for/
Share on other sites
Jack88 Experienced

Jack88

Posted
Posted

I have never seen that in a boot of a 32 before, looks aftermarket too me,you can see where it comes through from the cabin, factory runs dont normally go through there. have you tested it for power yet? has the car ever had a stereo or anything in it? also is there a fuse holder attached to the batter with the same cable going into it?

Rekin Grand Master

Rekin

Posted
Posted

pull out the rear seats and try and follow it to where it goes :bunny:

Pulling out rear seats takes 2 seconds. Two u-latches holding down the base one on each side. Shove a long screwdrive and pull up until the seat base pops out. Then you got access to the screws holding the vertical part of the seat, undo the 2 scews, and slide the seat up towards the ceiling to get it off the hooks.

Then have a look around at where it goes :bunny:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Milkmun
      S15 Spec R

      By Milkmun · Posted

      Wow that's a steal, you've done well there. 
    • trey318
      r34 gtt led globes

      By trey318 · Posted

      Exterior LEDs R34 2Dr R34 4Dr Position Lamp T10 T10 Winker front T20S T20S side T10 T10 rear T20S S25S150 Anti-hyfla relay TYPE3 TYPE3 tail T10 T20W Stop Lamps T20W T20W High Mount T16 T16 back T16 T20S number T10 T10 trunk T10 T10 Interior LED Item No.     Map Lamp BA9S single-sided     Room Lamps T10×31     Trunk Lamp T10     meter Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     Liquid crystal section T6.5 pedestal     Winker T6.5 pedestal     High Beam T6.5 pedestal     3 SERIES METER Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     air conditioner Early Liquid Crystal T3     Late LCD T4.2 Short     button T4.2 Middle     Hazard SW T3 Pedestal Short     Keyring T5     Cigar Socket T5
    • KyoyaR33
      Rebuilt Rb25det issues

      By KyoyaR33 · Posted

      Howdy all,   I had my rb25det S2 rebuilt and finally started it today but have run into a few issues  Engine sounds like a a diesel easiest way to summarise like small ticking, gets louder when revs are slightly adjusted  The engine builder repainted the engine cover leaving no where for me to go off with lining up the CAS so have it as central as possible so not sure it that could be affecting it?, changed the gearbox fluid too but won’t seem to go into gear when running, and only 1 to 4 when off having a hard time finding 5th and reverse anyone got any ideas or a base for me to start off? much appreciated 
    • GTSBoy
      Neil's R33 Gts-t Build

      By GTSBoy · Posted

      Well, no. It's an 023, which is pretty similar to an 040. Although it is hard to tell from the specs, as given.
    • GTSBoy
      My R32 Money Pit & The Headaches That Come With It

      By GTSBoy · Posted

      Hmm. Maybe the (other thing I forgot about!) Haltech removes at least some, if not all, of the problem I described. I guess there is still the possibility of getting it wrong if the AC is set up/wired up for the Haltech as if it was in an R34 (simply because it's on a Neo), and that's playing foul with the R32 AC computer.
×
×
  • Create New...