Jump to content
SAU Community

Recommended Posts

Iv got a mtx thunder 3404 four channel amp running mtx frount splits and mtx rear 6.5 speckers. It was working fine one morning on the way to work but later that day when i went to go home the speckers were just making a popping sound. Iv gone over and checked all wires and fuses and all are ok.

I then moved the earth cable to a new location and tested the power cable and that was ok. The amp is around 2 or 3 years old but has only hade about 20 hours of use.

My setup is

mtx amp running mtx frount splits & mtx rear speckers

pioneer amp running 2x12inch pioneer subs

sony indash dvd player

streetwires dual amp kit

Im hoping my amp isn't blown but its all i can think of :) "

Dave

Link to comment
https://www.sau.com.au/forums/topic/278884-mtx-amp/
Share on other sites

Do the subs still work or are they popping too? If it's only the fronts/rears or only the subs popping look below. If all of the speakers are popping then the pre-outs on the head unit may have died, again look below but try without disconnecting all of the speakers first.

Disconnect all speakers in the car at the amp, grab a spare (speaker) from inside or from a mate and connect that up. Hook an ipod/discman up to the amp instead of the cars head unit and see if you get sound. Make sure to turn the ipod right down before connecting it up of course.

Edited by nicr4wks
Link to comment
https://www.sau.com.au/forums/topic/278884-mtx-amp/#findComment-4712200
Share on other sites

Do the subs still work or are they popping too? If it's only the fronts/rears or only the subs popping look below. If all of the speakers are popping then the pre-outs on the head unit may have died, again look below but try without disconnecting all of the speakers first.

Disconnect all speakers in the car at the amp, grab a spare (speaker) from inside or from a mate and connect that up. Hook an ipod/discman up to the amp instead of the cars head unit and see if you get sound. Make sure to turn the ipod right down before connecting it up of course.

Good advice.

somtimes in falcons and magnas it's possible to snap the terminals off by shoving a big bag or something in there, i'd disconnect your speakers on at a time and check they're not shorting out.

but being an mtx amp, anything is possible.

Please advise how the original question had any thing to do with a ford and a magna installation?

STOP posting meaningless answers to peoples questions. This isnt the first time ether.....

Link to comment
https://www.sau.com.au/forums/topic/278884-mtx-amp/#findComment-4725277
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Unfortunately haven’t taken pics yet after it was finished. All the edges are hemmed nicely, just had to cut holes for the gear shifter and seat bolts and seat belt bolts in the rear. The molds seem like they’re done with steam and a layer of glue on the underside to hold a bit of shape but still soft enough that it’s a good fit when it’s all pressed down.
    • When's the rear mounted turbo kit coming? Needs dose and V8 chop idle lol.
    • I was very unimpressed with how the car came up from the A pillar forward, before I hit things (twice). It all has to go. It had to go, but now it has to go... more. So we finally found the very first Shennanigans with the entirely perfectly setup engine that had no problems being pulled apart to improve on 'was perfectly fine'. Cam bearings looked a bit... stock. Which isn't entirely bad given they were stock and this is a ~20 year old engine. So new cam bearings are on the way because it's somewhat difficult to get to this stage to do it later, and it will trash the block. It was quite unusual that it wasn't done when the perfectly new-looking VCM cam was originally installed by [unknown] What IS unusual is the cam that was installed there was advanced SIX degrees. As to why there is no way to know.. however it could have been @Dose Pipe Sutututu's mate who wanted a larger cam sound but also wanted it to come on earlier to be more usable. This is my dyno sheet with the previous setup - This cam is not supposed to peak until 7000+ RPM, according to VCM. This is what lead me down the whole 'my heads/intake setup is running out of puff and can't support the cam' line of thinking to begin with. Anyway too late now - New cam is in! It could be rather funny if this smaller cam acts like a larger cam because it isn't advanced six degrees. In the spirit of everything is working amazingly - the COMP cam required no dialling in whatsoever. It was about 0.5 degrees advanced, which seems pretty bang on. Any adjustment either way would be further out. I'm told as a chain breaks in it ends up regarding back about 0.5 a degree as the chain breaks in, making it bang on. In the spirit of everything was previously working amazingly - The timing gear that was taken out turned out to be was an N-Motion double timing chain kit, with adjustable cam gear (which is how it was 6 degrees advanced) and all looks entirely perfectly new. It also had a Torrington bearing, which was one of the reasons I ended up getting the Cloyes kit which they used in the C5R 24 hour racecar - Because I couldn't confirm what was in the engine when talking to Tony Mamo. I did believe however it was a Double chain kit of some kind... but found no supporting documentation or evidence for it.
    • I recently did this to my R33 with the full set from Car Mats Direct, they can't do the vinyl anymore that's advertised on the website due to a supplier issue so I ended up with the Black Loop Pile which looks great. I went all out with rubber sound deadening sheets from Repco and also added the sound deadening foam layer option with the carpet. Makes a world of difference and got rid of all the weird smells in the 29 year old interior. It was a bit of work but I'd 100% recommend it, Car Mats Direct had awesome customer service and quick postage. Replaced my seats with some sporty ones from Autotechnia while I was at it, feels like a new car.
×
×
  • Create New...