Jump to content
SAU Community

R33 Gts25t


Recommended Posts

Hey im assuming this is fairly normal granted its been pretty cold?? Drips a bit of water too. It all stops once its warm?

Just dont remember my old clubsport doing it quite as much...

Link to comment
Share on other sites

Hey im assuming this is fairly normal granted its been pretty cold?? Drips a bit of water too. It all stops once its warm?

Just dont remember my old clubsport doing it quite as much...

If it stops when warm its nothing to worry about! Mine does the same when cold.:D

Link to comment
Share on other sites

+1 to the mentioned above.....my car blows a heap of smoke when cold start and as soon as it warms up a bit then its all sweet......just try not to drive it when its really cold lol

nothing to worry about mate

Link to comment
Share on other sites

don't warm up your car in the morning. bad for your engine. wears your plugs, allows unburnt fuel to condense and drip down past your rings into your oil diluting it.

more relative to what you're talking about, if you warm it up for like three to ten minutes it will take MUCH longer to get rid of the water vapour. Doesn't hurt your engine... it's what it's designed to do. Warming up for 5 minutes is an old wives tale. or husbands. either way, it's lame and misguided.

best way to warm up your car in the morning and get rid of the water vapour is to nanna it until it reaches just under operating temperature (a safe temp is about 70-75°, suitable op temp being between 80° and 95°C).

Try it out, the lot of you. If there's one thing you can trust, it's a dude on the internet. (That dude is Doctor Karl, bitches.)

Edited by Dorigecko
Link to comment
Share on other sites

don't warm up your car in the morning. bad for your engine. wears your plugs, allows unburnt fuel to condense and drip down past your rings into your oil diluting it.

more relative to what you're talking about, if you warm it up for like three to ten minutes it will take MUCH longer to get rid of the water vapour. Doesn't hurt your engine... it's what it's designed to do. Warming up for 5 minutes is an old wives tale. or husbands. either way, it's lame and misguided.

best way to warm up your car in the morning and get rid of the water vapour is to nanna it until it reaches just under operating temperature (a safe temp is about 70-75°, suitable op temp being between 80° and 95°C).

Try it out, the lot of you. If there's one thing you can trust, it's a dude on the internet. (That dude is Doctor Karl, bitches.)

:D

Link to comment
Share on other sites

while it is a bit off topic, i am also against the letting your car sit there and idle to warm up. the main reasons being that it takes longer for a car to warm up when it's just sitting there idling, which means the car is running for longer at colder temps. the other reason being that it doesn't warm up the oil in the gearbox or diff.

another thing to take into consideration is that if you run your car for 10 mins every morning before you start driving, over a 1yr period, that is nearly 61 hours of running that your engine has done that hasn't been taken into account on your odometer, which means more than likely not taken into account on your servicing frequency. and not to mention the extra fuel you are using.

Link to comment
Share on other sites

good to hear it seems normal.

I dont really let it warm up by idling the car for extended periods. I just dont rev it or accelerate hard until its at normal temp...

Link to comment
Share on other sites

30-60secs then I drive it. Stagea (being auto) I cruise along at 1500rpm while people behind me hurl abuse. Skyline I shifted at around 1000rpm (3L ftw :blink:) till it was out of cold start (>65deg).

Just don't load it up.

Edited by bubba
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • That is typical (for a rb at least) with a medium to large turbo, noting the format of the graph is probably misleading what you see a little (half portrait width but full height, in landscape it would look quite different) Basically until it hits target boost the torque curve is rising steeply, when that is 4000+ rpm it is not great to drive since almost all of your life is between 1,000 and 3,000 rpm. Once you hit target boost the wastegate opens and torque stops rising so quickly. From there the shape of the curve depends mostly on the cams and where they have a peak vs the rev limiter
    • Last of the maintenance items for now....not sure why but the drivers side window switch had heaps of wear on the right front and right rear switches Unfortunately, unlike earlier Skylines the controls are bolted to the door trim from the inside. So....off the with door trim. There are bolts or screws: Behind the door handle cover, pop it off from the handle side Under the rubber trim at the bottom of the door pull (also just pops up) Behind the courtesy light at the bottom. Other than that, just window down then pop off the usual selection of push in clips around the perimeter and the trim lifts up Interesting that they have a bolt on cover instead of the old school plastic held on by goop....I guess they prioritised sound levels over price Then, 2 screws and 2 plugs to replace the switch (looks identical to the Fuga/Q70 one incidentally) and put it all back together. Also much better
    • ok I understand, but the majority of turbo vehicles lose torque, or have a flat torque curve after the spool.  hence my initial misunderstanding. I didn't think this type of curve was possible  
    • It is completely normal. Your original understanding is what was wrong, not what you see in the charts.
    • made with turbo and tuned by (hypergear)
×
×
  • Create New...