Jump to content
SAU Community

Recommended Posts

hi if anyone has these bits I need them, saves me getting them from nissan

Coil pack brackets to suit rb26 head

the plate that holds the rear main seal

water inlet pipe (the one that bolts onto the thermostat)

rb26 oil dipstick and pipe

rb26 coil pack loom in good condition

if anyone in syd has these parts lying around let me know and the price thanks

Edited by s13_Skyline_inside
Link to comment
https://www.sau.com.au/forums/topic/279134-wtb-some-engine-bits/
Share on other sites

I also need this part, its the fitting that screws into the back of the block, pretty sure it goes to the hose to the heater core, anyway its the thing circled in red and the pipes that go under the plenum chamber circled in yellow

post-12790-1247730779_thumb.jpg

post-12790-1247730489_thumb.jpg

Edited by s13_Skyline_inside

sorry i stuffed it up and put the same pic up 3 times the one with the yellow circle as well as the red circle is the one to look at,

I have the coil pack brackets and the loom now thanks, still need the rest

Edited by s13_Skyline_inside

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I might have to shoot them an email. Pity the exchange rate is so bad at the moment. BTW, thanks for posting that table makes interesting reading. 
    • Add these Sensors -Wideband, Oil Pressure, Fuel pressure, Intake air temp Good inspection of ignition system of coils, plugs and loom (12v feed and good ground)- a r35 kit is best bang for buck upgrade. A decent tuner should be able to see any issues with the trigger system- a link has good filtering but a good simple upgrade is the nz wiring bolt in kit. Check and replace all the fuel filters- you would be surprised at intank filter after a few years. Also good to check for any leaks on vac hoses and pipe work as has been said. No need to go overboard and spend big $$$ to enjoy the car. A quality tuner is getting harder to find as anyone with a laptop thinks they are a tuner. A link has great features to check sensor voltages and frequency inputs and easy to see live by pressing f12. The link can do a TPS & RPM fuel/ignition mapping on ITB cars then add a 4D table with MAP and ability to add a 5D to it (can help with economy at cruise with wheel speed vs TPS) Where are you located as that will help narrow down a good tuner ?
    • Reviving an old thread, I reckon my stagea is starting to slip. Car usually gets parked on a hill, narrow driveway so cant go up the driveway smoothly, anyhows, lately first gear feels "sluggish"? Not responsive. Feels like I gotta run the engine more than usual to get off the line...  Any recommendations for transmission servicing in Sydney? Or possibly just an excuse to go manual ?
    • Well, moulded carpets should fit well if the buck they use is the right shape. The finish is then just a case of stiching the trim around the edges. Shuoldn't be too hard to get it right. Back in the day, replacement carpets were all "fitted", in that they were stitched together, with cuts and slices taken out to make them form the shapes. Many more opportunities to get it wrong, hence all the concern over good vendors and bad vendors.
    • A timely blog via AASA (keeping in mind they sell brake fluid of course...) https://www.msbgarage.com/blog/news-and-blogs/brake-fluid-what-should-i-use/
  • Create New...