Safc2 Install

[Anquetil]

Hi, I have just wired in an SAFC2 into my stagea but have a problem, that being - it will not power off unless the battery is disconnected.

I remove the key from the igntion and it remains on. I have it wired to IG power as it states in the manual.

This is my first time wiring in anything electrical, any ideas?

[KiwiRS4T]

Which pin have you used for a power supply? If you give me an email address I can send you a WGNC34 pinout diagram and you can select the various power supply pins and use a test light to see which ones are live only when the key is on.

[email protected]

[QWK32]

there are two power wires, one of the wires gets wired to a perminant +ve, and the other goes to a +ve power source that only becomes active when the ign is on. most likely that you have this bit done wrong. post up the safc wire colour and where you sent it to? eg Green wire to rpm signal pin ## on ecu. And we'll see if we can spot a mistake.

[Anquetil]

Hi guys, have attached what I have done and what i'm working off. Power is wired into IG Power.

There is also no mention of 2 power wires in the manual either?

[andy65b]

Hi guys, have attached what I have done and what i'm working off. Power is wired into IG Power.

There is also no mention of 2 power wires in the manual either?

The white wire with black stripe is not the wire indicated on your diagram as the IG power. It would be the wire in the same row but at the bottom of that row.

That's what it looks like to me.

Cheers

Andy

[QWK32]

I agree with Andy. It looks like you've tapped into the wrong wire. In your pic, it's in the same row as the red arrow but you need to move it from the top wire to the bottom one.

[Anquetil]

Ahh thanks guys, when you've been looking at it so long sometimes the obvious isn't so obvious!

School boy error

Edited July 15, 2009 by Shane