Wolf Ecu Issue

[spoolmaster]

Hey Guys just have a question about the Load Calibration Table on a wolf ecu, i changed the "wolf sensor PSI setting" and now the car isn't running properly. can anyone shed some light on what i have done??? Any any tips to fix this this

Any help would be greatly appreciated

cheers

[paulr33]

change the setting back ?

[spoolmaster]

yeah tried that, the setting when i went into it was 0, i put it back on that setting and the car wouldn't run at all, so had to put it back to 15 just to get it to run.

[GTRNUR]

There is 2 steps to what you have to do.

First set the in the Wolf sensor PSI value and press set. The data is what the ecu will use to mathmatically calibrate the 100% load point after you do step 2 which is to use the "load calibration mode" and select the "WolfPSI load setup" option. Setting a lower boost setting than its tuned for is safer and will result in over fueling and less ignition advance meaning you wont kill your engine.

Really what you have done is pretty bad... If the ecu was laptop tuned and the tuner really knew his stuff he will have optimised the map sensors calibration to the engine meaning you may have a non-linear sensor calibration. You really need to have the guy that tuned it to fix the map to guarantee its 100% correct again.