Jump to content
SAU Community

Recommended Posts

I am about to buy a PFC Pro,

I have a series 1 r33 which to mind comes a shitty fuel map from the stock ecu. I was wondering if i can install the pfc and drive around with it untunded.

I have been told that the pfc's come pre tuned with some sort of stock like map. Is this true? The issue here is that I live in canberra and have to drive to sydney to get it tuned.

I was hoping that the pfc stock map would be better than the ser 1 stock ecu map.

Link to comment
https://www.sau.com.au/forums/topic/28131-power-fc-untuned/
Share on other sites

Yes it does come with a stock map, and yes it is better than the Ser 1 stock ecu map, and yes install away.

I noticed a definate power increase, not huge though. When it went on the dyno, AF ratios were still very rich, I think the base map may have a little more timing though which helps.

After fitting it was some 2 weeks before I got it tuned, and I had no problems even at WOT.

Be aware though, if it is second hand (probably good to do if it is new too) you should reset it.

You should teach it to idle before driving it around too.

Link to comment
https://www.sau.com.au/forums/topic/28131-power-fc-untuned/#findComment-585582
Share on other sites

Hi guys, I have never had a problem with the base map in a Power FC, running on 98 octane (Ultimate or Optimax). Used to be a problem on 95 though. Just check the knock sensor reading on the Commander to be sure, or watch the dash warning.

Link to comment
https://www.sau.com.au/forums/topic/28131-power-fc-untuned/#findComment-585927
Share on other sites

Just drive the car sensibly until you get the chance to get the car tuned.

I bought a brand new powerfc + commander and installed it in 1/2 hour or so at work in the car park, let it idle for 10min or so (just following the instructions turning air con on etc.) then drove around with it untuned for a week before my tuner was free.

Link to comment
https://www.sau.com.au/forums/topic/28131-power-fc-untuned/#findComment-585941
Share on other sites

I installed mine the other day and slowly started giving it more and more stick, all the while watching the knock sensor carefully. So far it's never gone above 33 even after a decent thrash last night. Since the warning doesn't come on until 60 I'm guessing I'm more than safe, at least until the weather warms up. With moderate driving it never goes above 20 or so.

Like Steve I've found the difference in power to be significant. The biggest difference is in throttle response off idle, which is now better than it was with a well-tuned S-AFC. Not much more power up top, but a bootful more in mid-range. I'm just going to run it like this until I can afford a tune, and then get it done just after putting the 550's in.

Link to comment
https://www.sau.com.au/forums/topic/28131-power-fc-untuned/#findComment-586435
Share on other sites

I am pretty sure greenline only sell new stuff.

to reset the ecu, you go into the 'etc' menu, highlight the reset ecu function, push next button, it will ask you to confirm, push next, then turn the ignition off and on and voila, all done.

I would highly recommend getting a copy of the commander pdf off the apexi-usa site. The download is for RX7, but most functions are the same.

Link to comment
https://www.sau.com.au/forums/topic/28131-power-fc-untuned/#findComment-586450
Share on other sites

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I would paint match the whole thing to avoid unwanted attention  I had a similar bonnet, paint matched, on my old R33 GTST, but mine was a fibreglass jobbie made by Blitz in QLD, they work extremely well for radiator efficiency and under bonnet temps
    • Does anyone run this kit with factory plenum? Does the adapter and bosch tb fit under factory strut brace? I wanted to get this setup before going forward facing manifold. Thanks
    • small update time, after always wanting a "cool" looking bonnet for my car and always struggling to find one for the series 2 that i liked and wasn't an insane amount of money. Saw one i liked on RHDjapan from D-speed in Japan the price was very good for a carbon bonnet so good infact i was a little unsure how much i trusted it, decided to bite the bullet and with the help of jesse streeter in not long at all it was at my door. Once it was delivered i ran in from work and quickly unboxed it and to my surprise the quality was actually pretty good i quickly removed the old bonnet and placed on the new one to test it out and even the fitment wasnt too bad at all. Then decided to paint the little grille in the bonnet black to stop it sticking out so much.   I decided to not mess around with the hood latch and just install some aero catch hood pins, having never installed them before did some YouTube university classes and i was good to go. fair to say it is not a fun job at all from making brackets so the pins sit nicely and actually cutting through the bonnet but also being very scared of cutting the holes too big it took wayyyy longer than i would like to admit but finally got it there. Then it was time for a quick test drive to ensure the latches actually worked and thankfully the bonnet looked very stable. I still think paint matching the bonnet and leaving just the part that sticks up as carbon would help make it all look alot neater as im not sure how i feel about all that carbon on a very fridge white car but will leave it as is and see how i feel with time.  
    • I think it's bound to happen, you finally get it all perfect, and bam, something will happen. I took a while to get a Commodore rear quarter repaired where a P Plater clipped it. Two days after getting it back, Sarah wiped it out on a concrete pillar in an underground car park... This is why I take forever to repair them, it stretches how long until it gets bent again... 😛
    • Nah, not really responsible for that little fiasco, but I'm still pissed at myself for writing off my 86, or when I reversed my VX into a pole just before selling it, but, meh, 5hit happens to stuff, all it takes is a slight distraction, and life is full of distractions, and "dooh" moments   
×
×
  • Create New...