Jump to content
SAU Community

Recommended Posts

Nick,

nah doubt they'll have media on them! just find out with the people who run the events to se eif you need it on, past events I have been to the photographers have just had fluro vests with nothing else on them!

Mate i know they wont have "Media" on them when i buy them lol. I was asking if the vest needs media on it for the event. And when you wrote back for example "I think they do" i would've said "ok well thanks anyway"

BUT

Since you have informed me that they may not need it. I will check with the organisers and go to bunnings lol

Thankyou very much mate!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Ohh even easier.   Go dial up 700rpm on the hand controller. Rip off the TPS plug, wait till the idle drops and then adjust the IACV screw so it's just a tad below the target on the hand controller (say 650rpm), plug the TPS back in and idle will climb back to target. Done.
    • Hey Sleepergm, I love your inlet piping, do u mind sharing who did the work, please? cheers, Ian
    • Yeah, you want the IACV to be running at around 30 "units", variously called "steps" or "duty cycle" depending on the person. That gives it room to go lower if need be and higher ditto.
    • Ah right that makes sense.
    • The RPM is just a target, the ECU will adjust things to try and hit that target but it's by no means guaranteed. If the IACV duty cycle is 0 or something like that and it's actually closing up fully then the idle is as low as it can physically go without reducing ignition timing. The problem can be something like the cold start valve in the IACV not closing fully, worn throttle shaft seals, torn rubber diaphragm in the brake booster allowing unmetered air, etc. 
×
×
  • Create New...