Jump to content
SAU Community

Recommended Posts

Need help with My R33 GTS-T , I put on a K&N Pod with adapter and Blitz BOV blocked the other one off and hooked everythin else up and now on low revs itll stall and was running a bit rough on idle then ran fine after a couple seconds , what could it be ?? I was thinkin maybe it needs a tune ?? any help is appreciated thx .

Link to comment
https://www.sau.com.au/forums/topic/282382-help-plz/
Share on other sites

DannyBro Bro. Our cars have Air Flow metres. We need plumb back items. Vent to Atmosphere are no good on deceleration of when we let go of the trottle as the AFM detects no plumb back air from the BOV and so the ECU runs rich to protect the motor hence momentarily flooding it and almost and if not stalling the engine.

The POD is fine.

Link to comment
https://www.sau.com.au/forums/topic/282382-help-plz/#findComment-4755542
Share on other sites

Yes pretty much because as I mentioned earlier. The ECU does not see air returning to the AFM when you let go of the throttle so it dumps fuel momentarily into the engine to protect it.

An aftermarket Plum Back BOV will do the job too. Get a dual venting one if you want the PSSHHHT Noise. Vents to Atmo and some back to the intake .

Link to comment
https://www.sau.com.au/forums/topic/282382-help-plz/#findComment-4755676
Share on other sites

I was under the impression that only the Djetro version of the power fc did away with using afm's?

personally I'd get a plumb back that also vents some, I had one on my old R34 gtt i think it was a hks ssqv if not then it was a copy

while it doesn't sound quite the same as a full atmo (I actually prefer it) it does the job right and you still get that venting sound.

Link to comment
https://www.sau.com.au/forums/topic/282382-help-plz/#findComment-4756187
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...