Jump to content
SAU Community

Recommended Posts

Hey guys,

Selling this due to upgraded to a higher power amp.

Works great, barely used - fantastic condition, in box with manual.

2 Channel

5 - 38,000 Hz frequency response

2 x 50W RMS @ 2 Ohms

2 x 40W RMS @ 4 Ohms

1 x 100W RMS Bridged @ 4 Ohms

Asking $100 or nearest offer. Pickup in Adelaide or will post at buyers expense.

PM or call/sms 0413 733 433

Cheers,

Lucas.

p8090008.jpg

Edited by stolen-gtr
Link to comment
https://www.sau.com.au/forums/topic/282625-fs-fusion-powerplant-amplifier/
Share on other sites

  • 2 weeks later...
  • 4 weeks later...
  • 4 weeks later...
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • MBS206 Did u just take the “Limitless” pill? cause that was way over my head, much respect bro 🤜🏼  
    • I personally haven't been in this situation, however have repaired a cracked radiator using JB Weld and held up until I could replace it with a Honda Accord years ago. Maybe @GTSBoy might have a sound strategy?
    • Hi Dose, I know you'll be reading this thread. Brake pads are going good mate thanks. Anyway, pulled the 33 fuel tank out today because we were limited to a disgusting 480hp on the old fuel pump setup. On pulling the tank, I found the cracks in the photo (I don't think they're leaking, but fuel evaporates quick so hard to tell). What's the best way to repair, or is their a new tank alternative? Thank you.
    • Update on the car... I took video of about 9 minutes of it running, shortly after start up, and the car sounds OK? I replaced the ATS and confirmed that the new/old one are showing warming than freezing teamptures. I will replace the wideband tomorrow, but maybe this video can give some insight. Logs of warmup - https://drive.google.com/file/d/1bpvfmsLfZEjg_rBZw8IseAuM3iWq3BGN/view?usp=sharing
    • It's easy to tap to the other CAN networks, and in addition, most of the stuff you'd want could be obtained by querying the data over UDS on the network available on the OBD2 port. That said, it's much nicer to just listen on the appropriate network to data that's being streamed rather than querying in steps using OBD2 or UDS.
×
×
  • Create New...