Jump to content
SAU Community

Recommended Posts

u using fibre glass copy front bar??

Wouldnt think a genuine bar/factory plastic would crack like that.

Ive seen cars running genuine kits and hit much bigger things and come out less worse for wear then that.

plastic won't crack like that no, but the paint can still crack if it flexes too much. i put my pulsar in a ditch one night (was doing a 3 point turn on a dirt road and couldn't see a drain on the side of the road and the car just slowly slipped down into it). the front bar was pushed back against the radiator support (so it moved about 15cm) and had the weight of the car pushing down on it. once we got the car out and took it to the carwash to wash the dirt off there wasn't any damage at all. a few fine scratches and that was it. i was expecting the front bar to be stuffed as well as the radiator supports etc, but they are all fine. i also hit a hare at 80kmh in my vx commodore and didn't even mark the paint.

the problem with some fibreglass bars is that they are so flimsy. i have seen some that just about break if you pick them up by 1 end (they flex too much and are so thin they just about tear). however that can be a good thing if you hit something with the corner of the bar it will just flex. i made mine so thick along the bottom that you could just about hold it out straight just by holding it at 1 end.

  • Replies 115
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

I hit a fully grown hare at 120Ks, and iv hit another at 100. Lots and lots of near misses with rabbits too.

f**ked my front bumper and went through the plastic that starts under the front bumper and ends at the tires and finally went under the wheel which spat his guts underneath the rest of my car.

################***********#WARNING WARNING WARNING PLEASE READ#####################****

Rabbits and hares are totally f**kn retarded animals and you should never think that they are moving out of your way, the stupid shit for brains things will run off to the side and then turn around and run in front of you OR if you see them on the side of the road they will run onto the road (i don't know why) and commit suicide.

p.s

Chickens are dumb too

.

Edited by R34 -_-
I see your hare at 90km/h and raise you a coyote at 320km/h

clicky if you're not squeamish

http://i154.photobucket.com/albums/s245/54...uff/coyote2.jpg

http://i154.photobucket.com/albums/s245/54...tuff/coyote.jpg

hahah holy shit.

wat new front bar you getting on there? insurance would cover the custom paint work and everything yeah?

hahah holy shit.

wat new front bar you getting on there? insurance would cover the custom paint work and everything yeah?

its called the CM4 , its on carmate.com.au not a bar that everyone is gonna like but ive fallen in love with it lol and yeah graphics are all covered too :)

ouch cara, hope you get it sorted out soon :)

was it in the day or night time?

yeah she goes in on monday to start having things fixed, getting my bonnet underneath resprayed and parts of my engine bay resprayed (at my own cost tho) so gonna start doing that from monday and then hopefully new bar will have arrived by end of next week

was at dusk....but the thing is was the only animal i saw on the road at dusk :D

haha were u freaking out.. most of the chicks i kno would be so freaked out if they hit a little bunny hahah

ps: just looked at the bar on carmate, my mates got the same on his 34, looks pretty nice, his cars sitting real low aswell.. not long until its got countless cracks :D

Edited by r32na

Weird, I hit a fox pretty hard at 80-90kph back about 18 months ago .. barely did any damage at all - factory bumper though, so I guess not likely to shatter or anything like fibreglass. I just needed to replacement bumper....

20080121_damage4_thumb.jpg

Mostly I was just annoyed that if I had of been doing the speed limit, or on a straight bit of road I probably would have missed it. Unfortunately it was 1am in the morning driving back to Adelaide, I was taking it easy and on a sweeping bend so I didn't really feel safe swerve to avoid the fox when I caught it in my headlights before it hit.

Anyways - good luck with the repairs Cara. Love to see pics of the completed new front bar :P

just patch up your existing bar and put it back on >_<

too many hairline fractures thru out the whole bar so probably not really worth it......as soon as Blue (my crash repairer) had a look he said it would be easier to get a new one......

it will give me something to do aswell.....ill fix the bar (spend a lot of time on it) and then sell it maybe......if i take it as far back as possible and strengthen it up as much as i can it will reduce any fractures coming up hopefully :down:

I collected a hare also one night, straight into the intercooler. I must say the bunny came off second best. Not a dint or crack/break on the front bar and the cooler was fine. Although there is a slight warp in the mesh. I was pulling tufts of bunny fur out afterwards though hahaha

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeah its bad eh. Ey! Watch your mouth. Yep, spot on. The rear's are always gone too though from brake checking. I had them perilously close to a tree that we had taken down. I think the tree peeps may have taken it. Either for a trophy, or accidentally.  
    • f**kin' yikes! That insulation is the shittest stuff I have ever seen. You need to do an insurance job on that f**ker, pronto. WRT to the washer cover, I would have said that there'd have to be some at a wrecker, then remembered that it's a BMW, and reasoned that every single wrecked one would have been tailgating and so the front end would be trashed.
    • Oh and I lost my headlight washer jet cover!
    • Ok, so I got myself some X1 wheels really cheap to try out, they're a bit different and I like them but they're really narrow (18x8) they are available in staggered 18x8/9 also but really hard to find.  I kinda dig them, but not as much as the F10 19's I usually run, so these go into the wheel pile.         As I mentioned in another thread, I got a new exhaust. It's an off-the-shelf stainless one that fits OH-KAY. I don't love the tips size and how far they come out the back, I think I might cut the tips off and replace with some smaller (~3") ones that don't extend as far. It sounds really good though, I'm not sure if its just in my head but the car feels a little quicker, more responsive.      I fitted an eBay special front lip. Surprisingly it fit perfectly and all holes lined up. Its a little rickety but I haven't put any double sided tape on yet, I want to clean the front bar up where it has scraped the road a lot and fil in the number plate holes (or, get body coloured wrap to cover them - is this a thing?  I'm not sure if I'll leave it gloss or pain it matte. I really like it though, I don't particularly like the front bar without it, I don't really like the M-Sport and to get anything else is just too expensive. That said, I might need a new one now anyway as I dropped the car onto the jack after forgetting to put ramps under the front wheels. It bent a lot and while it did go back to normal after I got the car off the jack, I do fear I have not done it any favours.    Lastly, my headlights died. Different problems in each. They have gotten much dimmer over the past year or so, I put new (uber expensive) OSRAM bulbs in them but to no avail. One of them pointed at the ground and the other just kinda did its own thing with light working sometimes. Yeah, check this 18 year old BMW headlight wire. I reckon I know why they were stuffed.            BTW, the yellow and black is the power to the Xenons. Yikes. I hunted around an researched my options here. I would have loved to just get a replacement harness but not a thing. My car has adaptive headlights, that is they rotate left and right with the steering wheel. Good condition used adaptive xenons were over $700 each, non adaptive were around $400 each, but I couldn't help but think that they're all around 18 years old now, surely they'd have the same problems. So I looked at newer LCI headlights but they were even more expensive and I couldn't confirm that they'd be plug and play with lots of people having lots of opinions so not worth the risk.  I ended up getting brand new Chinese headlights from MARS. They're very close to OEM with only the angel eyes being a bit different. I didnt want crazy turn signals or sharp DRL's or anything. Not my bag.  They're not adaptive, I thought thats a feature I wouldn't really miss. So I coded that out.  The lights are awesome, they look so nice and they take so many years off the car. The angel eyes look great and the headlight brightness is ridiculous. I was so used to the old ones, I didn't realise just how bad they were. The new ones use the OEM bulbs, Xenon ballast and leveller motor which I was happier with. The only issue with them is that the rear cover is held on by SEVEN screws. This will be a nightmare to get to and open when I need to change bulbs.   
    • Now that you mention it I can see those too. More subtle. The lighting and low resolution makes it hard to assess super well what's going on but what is visible is bad enough to pull the motor.
×
×
  • Create New...