Wanted : Rb26 And Rb25 Cylinder Heads

[200] · 2009-08-18T04:21:22+0000

HI, Looking for either an rb26 or rb25 cylinder head for rb30 twin cam conversion. If you have either available please let me know - would prefer a more complete head with covers and inlet manifolds. Exhaust manifolds / turbo's are not required. Pictures, location and prices would help a lot. Thanks

By [200],
August 18, 2009 in Wanted to Buy

https://www.sau.com.au/forums/topic/283907-wanted-rb26-and-rb25-cylinder-heads/

Followers 0

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign in

Already have an account? Sign in here.

https://www.sau.com.au/forums/topic/283907-wanted-rb26-and-rb25-cylinder-heads/

Followers 0

Go to topic listing

Announcements

Similar Content
- 14
  
  RB25 S2 Idles but doesn't want to rev
  
  By Trilbyte
  Started November 15, 2024
- 10
  
  R32 RB25 head and block
  
  By Prof_Finesser
  Started October 20, 2024
- 27
  
  PRP RB26 cast block + head prototype running
  
  By joshuaho96
  Started November 9, 2024
- 16
  
  R32 GTR clutch master cylinder adapters
  
  By weikleenget
  Started November 27, 2024
- 7
  
  RB25 Crankshaft Differences
  
  By LjB123
  Started December 10, 2024
Latest Posts
- Hicas ball joint install tool
  
  By Dose Pipe Sutututu · Posted 17 minutes ago
  
  Please throw out the entire HICAS junk, it's literally just that, junk.
- R34 GTT Central Locking Pains
  
  By DraftySquash · Posted 1 hour ago
  
  Thanks everyone! I'll take the remote apart to clean the contacts and see how it goes.
- My BMW 335i
  
  By PranK · Posted 1 hour ago
  
  Balance to the force has been restored.
- R34 GTT Central Locking Pains
  
  By silviaz · Posted 3 hours ago
  
  Not sure if this helps but I had a similar issue where one of the doors wouldn't lock unless I pressed the lock key twice. Turns out the door actuators were f**ked. In the Nissan service book it says to lube it every now and again, I guess put a bit a bit of wd-40. I replaced mine and haven't had a problem since.
- Hicas ball joint install tool
  
  By GTSBoy · Posted 3 hours ago
  
  2 things. 1. If you're going to buy a ball joint puller/pusher tool that is not advertised as being for the purpose you intend to use it for, then it is up to you to make sure, either before you buy, or after you first try (and possibly fail) that it will work for that task. 2. WTF? Putting HICAS balljoints back into a car implies retaining HICAS, which is just....dumb. HICAS can lick my left one.

Sign In

Wanted : Rb26 And Rb25 Cylinder Heads

Recommended Posts

[200]

Link to comment

Share on other sites

Create an account or sign in to comment

Create an account

Sign in

Announcements

Similar Content

Latest Posts

Forums

Activity