Stripped R33 Loads Of Aftermarket Parts
Announcements
-
Similar Content
-
-
Latest Posts
-
With the obvious caveat that hub dynos are not telling you rw power. They are telling you flywheel power minus drivetrain losses. The largest losses in power readings at the wheel are, of course, at the tyre-roller interface. -
nice, that should get you to the shops and back ok -
By TurboTapin · Posted
After a quick revisit, I'm now at 478rwkws @ 27psi on a mustang roller dyno. -
By TurboTapin · Posted
That's unfortunately not an option due to the short length I need (~50mm). I've always ran submersible rubber hose without any issues. It is also what is in there from factory. Thanks for the tip though! I was back on the dyno again today to play with VCT rpm and knock thresholds. In the end, the best gains were with keeping VCT on until redline. I gained 15rwkw at the top end. I'm now sitting at 478rwkw @27psi on a mustang dyno. For science and not for bragging rights (I'm full of shit), next time I'm bored, I'll visit one of the many mainline hub dynos around me to do a pull. I'm confident it would be 500+rwkw on a hub dyno. Tuner once again mentioned I'm leaving a lot of power on the table due to my rev limit/hydro lifters. I may or may not entertain going solids at some point in the not so distant future. I also don't really need any more power for the street... it's already more then enough to kill myself. VID_20240627_151737.mp4 -
Pretty easy here too. I just don’t want to take up too much of my time getting rental, returning it etc. the lazy part of me wants to just pay someone to take me lol.
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now