Side Skirt Grommet/screw

[Race__24]

I'm trying to find a part number for the grommets and screws that secure the nismo and probably other side skirts onto a '98 S1 RS4 stagea.

The ones i need fit into a 10mm round hole under the car, the plastic bit pushes into the body and then there is a screw which screws in fastening the metal side skirt bracket to the body.

I've been into nissan but thew weren't much help and pretty much gave up before they started and the one they did come up with was a square plug.

If I'm not asking to much could someone also look up the clips that snap in from the side also, I found some that half work but if i could get the correct one that would be great.

Thanks

Aaron

[floody]

Keen to hear this one myself; mine is missing a couple of the screws.

Also if you could come up with the P/N and description for the sideskirt endcap for a S1 Dayz, rear drivers side, it would be a godsend.

[Duncan]

no need to deal with nissan - any car bits store will sell an equivalent clip you can use.

[Race__24]

Ok, so far I've been into Motortraders, Sprints, Supercheap, Autobahn, Nissan, 2 paint and panel places and done a lot of searching on the net. The closest I can come up with is a Hyundai & Kia Headlight Assembly Grommet Whith is nothing like the original.

No one seems to make much for round holes, there is heaps of stuff atound for square holes and smaller round holes but very very little in the size that we need.

I went into another Nissan dealer today, we managed to find the side skirt fitting kit, and the end cap(I'm missing one too) but unfortunatly the trail ended there, the part was no longer listed or something.

Edited September 15, 2009 by Race__24

[floody]

\

I went into another Nissan dealer today, we managed to find the side skirt fitting kit, and the end cap(I'm missing one too) but unfortunatly the trail ended there, the part was no longer listed or something.

Get all the codes anyway, theres a few avenues to try. Given the random Japan specific sh..stuff I can still get for my 21 year old HR31 new from Nissan, I'd be surprised if much of anything is NLA for the stags.

[Race__24]

Hmmm, that's what I thought too, maybe cos it's a NISMO kit it wasn't in production for as long

[Duncan]

but...you just need an equaivalent faster, not the same.

if it has a hole and access to the back....a bolt with nut will work if necessary.

if it is a hole within 1cm of the edge of the sheet you can use the spring clips that take self tapping screws.

if its a hole with no access to the back get any of the plastic clips with the right outer diameter and shove them in. when it comes no nylone grommets a square peg most certainly will fit in round hole

worst case most bodykits in this world are held on with double sided tape...

do you have a pic of the problem?