Jump to content
SAU Community

Recommended Posts

Just purchased an autotechnica "MONZA" intercooler and piping to suit my RB20 "32 and after all the cutting of front bar and modificatons to fit the intercooler to car etc etc etc the piping that goes to the intake fits nearly 100% except it sits a little to high and I cannot full close my bonnet successfully with pushing the piping down onto the radiator fan which is then munched it is spinning :blink:

Anybody else had/has this problem??

Anyway of fixing this?

Link to comment
https://www.sau.com.au/forums/topic/288197-intercooler-piping-problem/
Share on other sites

  chalky said:
na the pipes arent to bad..

will it matter all that much if the fan trims itself down??

I had the same problem on my 33 - the fan eventually trimmed itself down and now it doesn't hit at all really. the fan still functions as it should and spins fine.

Its only approx. 1cm on the edge of the blades that have trimmed down.

If you wanted to you could probably trim the edge of the blades yourself before the piping does it for you :blink:

  chalky said:
also wopuld autobarn/ supercheap auto sell silicon hose that 2.5"-3"

supercheap have them i think but they are expensive from memory. Autobarn didnt have a huge range from memory.

i really desperately needed a silicon hose for one of the joins in the cooler pipes and it cost me like $50!

  brentos said:
supercheap have them i think but they are expensive from memory. Autobarn didnt have a huge range from memory.

i really desperately needed a silicon hose for one of the joins in the cooler pipes and it cost me like $50!

Yeh supercheap stock them, but they are a bit expensive its about $38 for 10 inches of silicon (straight)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...