Jump to content
SAU Community

Recommended Posts

Hi ppls.

Thinking of selling my rims, just seeing if there is any intrest out there.

5x114.3 stud pattern so suits Nissan and Toyota

18x8 +32. 225/40/18 Nankangs approx 90% Tread

18x9 +35. 235/40/18 Nankangs approx 90% Tread.

Im not 100% on the offsets as the stickers have come off but are very close to what i have listed them as.

The Rims are in immac condition except for one minor mark on one of the rear rims.

These fit perfectly on my R34 GTT.

Located in Perth Will Send interstate at buyers expense.

$2700 ono

Ph: 0422151003

post-12968-1253669083_thumb.jpg

post-12968-1253669175_thumb.jpg

post-12968-1253669202_thumb.jpg

Edited by nismor32gtst
Link to comment
https://www.sau.com.au/forums/topic/289158-18-volk-gtcs/
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Hell, I know that much. So far I just put it off as "part of the deal".
    • I removed the head expecting to find broken and bent valves, but instead found number 1 at TDC and cylinder 2 at the top of its cylinder stroke as well, thought that was weird and proceeded to push cylinder 2 back down until it either bottomed out on its other piston half or the conrod either way we found the issue kind of,  now to remove the engine and see how the block looks, hopefully its just the top off a piston.  
    • A little more work this week.  Fitted astra power steering pump in the boot with a lowe fabrication bracket. Gave the pump a good clean, fitted Anderson plug and high pressure fitting. With the intercooler being flipped under rad support factory headlights weren't going to work. Ordered a set of origin battle lights, they arrived so got them test fitted. Will require some fiddling to fit nice but was an easy quick option for now. And today we pulled out the manual Rb gearbox and test fitted a ZF 8HP50. It will fit with some casting tabs cut off and small tap of the tunnel with a hammer. Pick up the adapter plate Wednesday so hopefully all bolted in Friday and measure for tailshaft which will be a 2 piece. Been doing a lot of ecu, pdm and tcu loom design so when comes to wiring it in a few weeks will all go smoothly.
    • FYP. Sadly. Even bolt cutters wouldn't take 2 sec. But in the days of 18v angle grinders, nothing is safe.
×
×
  • Create New...