S14 With Neo Rb25 Drift Car.

[DJRIFT]

Looking good. If you can afford to I'd carry a spare water pump. In the past they were very unreliable.

Id been wanting to roof mount a switch panel like you have done but my roof bars are in te wrong spot to work properly. Good to see someone has done it and done it well

[Simon-S14]

still working on it.

lowlights today - front oil seal let go. soaked clutch, started slipping on dyno. this was 2pm. remove box and clutch. take it down to ACS new pucks fitted and a clean up done. new oil seal. refitted and then refit the whole lot by 530pm.. dyno shuts around then also.. Asked cece from jaustech if we could use his however Steve from All Make Motors offered to stick around and let us finish the tune. this was done by 9pm.

High points?

25psi runs on stock bottom end.

and

Launch control and 2m long flames.

the results... 412 rwkw on 24psi

MANY MANY thanks to Steve from AMMRR, Decs and Steve from Garage7, Craig, Aran, Bayden, Mitch and the guys from ACS for helping today

[Reese69]

sorry 400kw on stock rb25 block? you must have alot of faith in the motor.. im nervous drift mine with 300.. how much torque -

[Simon-S14]

stock RB30E bottom end mate

635nm at the engine

[Simon-S14]

heres some pics

[Reese69]

yum.............

you didnt waste any time to hit the track

sorry missed the rb30 bit -

Edited October 6, 2013 by Reese69

[Simon-S14]

[DJRIFT]

Thoes wheels look so good in motion.

[Simon-S14]

[Simon-S14]

[Simon-S14]

[JH32]

Love it! Great driving!

[Simon-S14]

[SCR48]

Quality build and even better driving!

[Reese69]

love he shop of the wheel and that engine sound keep the vids up..

any further plans?

[Simon-S14]

susp tuning in the short term... finish off little bits and pieces and make that rear rad work mint.

larger plans can come later... i just wanna drive

[ido09s]

are they GTR front hubs?

I couldnt see a drive shaft so how are you keeping the wheel bearings together?

[Simon-S14]

no they are GKtech aftermarket knuckles mate

[ido09s]

Given what i thought was a driveshaft hole in the centre they looked like GTR ones and was wondering how the hell they werent coming apart lol

[Simon-S14]

Haha fair enough. They are actually a press in stub axle and bolts in from behind. It does look a bit like a gtr hub tho