Jump to content
SAU Community

Recommended Posts

hi

i own a 1996 nissan skyline r33 gts-t and i was just wondering how much power can a stock turbo handle?

what mods can i get to make my skyline fast without blowing up the turbo?

i was planin to get a front mount intercooler and a aftermarket computer would the stock turbo handle that?

Edited by peter21

around 200 - 220kws is all it will take, and not for long!

Mine is at 203kws running at 15 pound right now, I've already got a new turbo though so I don't care if it blows.

It could live on 180kws for a long time, I wouldn't put it past 10psi if you want it to last.

power figures are all depending on other mods as well...

around 200 - 220kws is all it will take, and not for long!

Mine is at 203kws running at 15 pound right now, I've already got a new turbo though so I don't care if it blows.

It could live on 180kws for a long time, I wouldn't put it past 10psi if you want it to last.

power figures are all depending on other mods as well...

I thought that aswell.... until i saw a bloke have to rebuild his motor because it ingested the busted turbine when it finally blew..

I thought that aswell.... until i saw a bloke have to rebuild his motor because it ingested the busted turbine when it finally blew..

I'll bet you a steak sandwich it wasn't the turbine. Engines don't breath in reverse and any chunk large enough to go back through the manifold after the explosion is not going to have a shit show of getting between the piston and bore

The highest I've seen is 223rwkws and it lasted about 20mins. Mine had 215rwkws on Dr.drift remap using a RB25Neo turbo and it was missing half of the turbine fins when I took it out 3 weeks later.

adrian has made around 270rwkw on the standard turbo

this was with NOS. so i think the question the original poster has, is what boost pressure kills the std turbo

its around 12psi. 12psi is the ok / risk level. it may work fine for years or it may shit a bearing in 20 minutes

ive had mine at 0.85kgcm2 for about 5 years now, got car at 58k and its now got 215k on the clock and still std turbo at 0.85kgcm2

so its luck of the draw

power doesnt kill the turbocharger, excessive heat, shaft speed (from running mega boost) and poor tune (excessive egt's) are what kill the turbocharger

around 200 - 220kws is all it will take, and not for long!

Mine is at 203kws running at 15 pound right now, I've already got a new turbo though so I don't care if it blows.

Is that a good idea? What if it fails catastrophically and bits get sucked into the engine?

Edit: Opps I see that was partially answered but still bits of turbine blades all through the 'zaust/cat can't be good, plus also if the compressor side fails couldn't you at least get a load of oil fouling up intake etc

Edited by Tony de Wonderful

i got my r33 series 2 running on 12psi...175kw atw..but only drove it for about 4 hours on 12psi till my coilpack failed...but im looking at putting a remaped ecu so il be getting around 200kw on my stock turbo, and my tuner said it will be ok.

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • So, the other thing I've sorted is a baseline dyno run up at Unigroup's new location. The auto trans was a little unco-operative by both shifting down when the throttle was floored on the dyno (so Mark had to ramp it up more slowly than in a manual) and also by shifting up at 6,000 even in sports mode instead of the indicated redline of 7,000 Still, on a hot day it made 240rwkw at 16psi which seems about right for 300kw (400hp) through an auto at the wheels.  The shape of the curve is not quite right because it was not full throttle to about 4,500 to stop it kicking down, but until I can get a tune on the auto trans control this was the best we could do.....full boost will be well below 5,000 once that is sorted, I'll get some data logs when I can to confirm For comparison, the R32 made 255 at 12psi (at 4,500) on the same dyno with tune, n1 turbos, cam gears, big exhaust but otherwise all standard so the v37 is likely a little better out of the box. One thing that is very clear is that the standard water to air intercoolers are not up to sustained use at full throttle in warm ambient temps. After about 5 runs (so only a few minutes full throttle), it was pulling boost and timing and dropping 10-15% power. Unfortunately I didn't get that printout and the Unigroup guys are away at the moment, will try and get hold of it on their return. So, looks like a healthy engine to start modifying and the only real area of concern is the w2a heat exchangers which the aftermarket has plenty of solutions for    
    • I maintain it actually looked really nice in person. So much so that I thought "No, this is illegal" but there it was, clear as day. I think we can easily call the wing and wheels/height to be transformative. Not saying it's better than the GR Whatever, or the 86, or the WRX STI or anything of that sort (the internet says it all bolts up so you can buy best of all worlds?) but it's still at least a thing and not nearly AS bad as people say.
    • That's less offensive than the previous gen.....except for all that ugly black tupperware around the edges. Blerck!
    • I leant out the window recently and took a picture of this new WRX. It looked real damn fine in person. It's faster around a track (stock) than a (stock) GR Yaris. It's much more practical despite being heavier. It's significantly cheaper. This gen tunes really well, much better than others. .... I think they're probably a lot better than people expect.
    • WRXs are a pure pleb boring car these days. You need to get an STI to even get close to what a WRX used to be.
×
×
  • Create New...