Jump to content
SAU Community

Recommended Posts

Silver 33GTR with CL ### plates... headed down Mt Ouzley into Wollongong very sedately, stuck behind a slow truck, I gave you some room but you decided to wait...

one very clean ride!

I've also seen a yellow 33 and a black 33 GTR (i think) coming down there too

And a Black 33GTST stopped next to me at the lights in Wollongong near Masters Rd, chick driver, older guy in the passenger seat.

I didnt think to catch the plates.

Edited by B. J.

Spotted a Maroon 33 GTR with huge "Buddy Club" stickers all over it

Also spotted a grey 33 GTST boosting past Chatswood station..series one i think.

Also spotted an S15 with the "Ikeya Sequential" H pattern convertor thing. Man that thing looks chunky....i like it

Spotted a silver and two black R33's (all GTSt's) and a silver R34 GTt sedan heading down the F3, Pennant Hills Rd and the M2 on their way to Friday night drags at EC.

All Central Coast and Newcastle people, apparently...

Spotted Primordial on Monday just leaving just jap!!!

;)

o o o and B-mans Cosmo outside Hitman on Monday night! Looks good! Man those brakes, they are MASSIVE!

Hey! What car were you in? I remember seeing an S15 going the other way when I came out..?

Spotted a silver and two black R33's (all GTSt's) and a silver R34 GTt sedan heading down the F3, Pennant Hills Rd and the M2 on their way to Friday night drags at EC.

All Central Coast and Newcastle people, apparently...

Hey,

I was the R34 GT-T Sedan - I actually live in epping but I work on the coast so hang with them mostly.

Thought it was Goldzilla car but on the two ways the others were thinking of someone else, till that talked to ya.

Drew.

Hey! What car were you in? I remember seeing an S15 going the other way when I came out..?

I was in the car behind the s15..... which was the Proton :( lol

I must have missed you by less than 3 mins!!

Hey,

I was the R34 GT-T Sedan - I actually live in epping but I work on the coast so hang with them mostly.

Thought it was Goldzilla car but on the two ways the others were thinking of someone else, till that talked to ya.

Drew.

Hahaha, hey Drew. I was driving, and my cousin (his username is "blukie") was talking on the UHF CB's. Didn't get to chat for long because the batteries went dead on the CB - I think I've had the same batteries in there since I bought the thing years ago (it must be at least 4 years)...

Who was it that said my car was the "green Camry-looking thing..." over the CB's? :(

Even worse is that someone didn't know what a Stagea was - there are a few up Newcastle way, and they are on the forums too! :ninja:

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • How to wreak havoc at a bogans party... Swap out the goon bag hanging from the clothes line with oil bag... Watch chaos ensue during Goon of Fortune....
    • Hey everyone,   I’m looking for some advice on replacing the timing belt on my RB25DET Neo-powered 1998 Skyline. The engine was fully built about five years ago, including a fresh timing belt, water pump, and other essentials. However, since then, the car has only covered around 2,000–3,000 miles. It’s currently making around 650hp.   Even though the mileage is low, I know timing belts have a time-based lifespan too, and most recommendations suggest changing them every five to six years or 50,000 miles. Since I’m at that time mark, I’d rather not take any risks and plan to swap it out soon.   A few things I’d like to hear opinions on: 1. What’s the best belt for this setup? Should I go with an OEM Nissan belt, or is the HKS fine-tune a better choice given the power level? 2. Would you bother replacing the idler pulley and tensioner at the same time, or only if they show wear? 3. When swapping the belt, is it necessary to lock the cam and crank gears in place, or is lining up the timing marks enough? I’ve seen different approaches, and I want to make sure I do it right.   The water pump was changed with the rebuild and isn’t run off the timing belt, so I don’t see a need to replace it again. I just want to make sure I approach this the right way.   Any insight would be much appreciated. Thanks!
    • How does this compare to the internally gated g25-550 in terms of power production at same psi and spool
    • Did you find that your voltage of the battery wasn't where it's normally supposed to be? for example on my r34, it's at 14.5v when running after a few seconds, but I noticed when I had a rough start and it initially wasn't idling correctly, the voltage on my triple gauge cluster was showing lower than usual. Seems like the alternator is starting to crap itself
×
×
  • Create New...