Jump to content
SAU Community

Official NSW Skyline spotted thread


CerealKiller

Recommended Posts

spotted wtf 33r last night i was in my mates forrester and u wouldnt run. soft hahaha

i spotted him on friday night at thornleigh maccas... i should have gone over and said hey but i was eating :)

Link to comment
Share on other sites

i was pretty smashed last night but i think i saw SP-00-LZ last night turning on geroge st around 2ish, it was an r32, duno wot colour though... :)

lol, you must've been pretty smashed if you could see the plates but not the colour of the car. Nice one

Link to comment
Share on other sites

spotted ULOOOK on the foreshore at newi at around 4pm on sunday, heap of other lines aswell, but didn't get plate...memory can't remember that much :)

I seen your car too. You should have pulled up and said hi!

I seen OPASEN and a really nice black 33 in there too. I'm not sure who he is tho.

Link to comment
Share on other sites

Spotted a yellow stagea parked P plater in merriweather beach

Dark blue 32 gtst in pacific hwy, swansea, And a 33 gunmeteal grey with a big wing and nismo sticker on the front round lake munmorah yesterday.

This morning Spotted Amy33 on gardeners road mascot at 12pm

Link to comment
Share on other sites

Spotted a schmick black R32 GTR at Hornsby/Berowra about 5.30 yesterday arvo... got a wave... can't remember plates but it headed down Berowra Water Rd... Anyone on here???

think it was me

i drive a stock gtr

you went up to the freeway

nice to be spotted :domokun:

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • From there, as the manual says....assembly is the reverse of disassembly, no tricks worth mentioning Much better (for me)
    • In my case, the standard wheel I had was in good condition but the buttons had more wear, so I swapped them across from the original wheel from the car. The plastic rear cover is held on by 4 tabs, and once the wiring is removed you can get access to 2 screws on each side the hold the buttons in From there I just swapped the wiring over. What was interesting is the standard style wheel is 2.0kg but the carbon fibre one is 50% heavier at 2.9kg. It even has a weight inside the wheel at the top to make up for some sort of imbalance in the design. weird
    • Once the airbag is off, to remove the steering wheel.... Undo the 2 plugs into the clock spring, and the horn connector from it's clip. Hit the 19mm nut with a rattle gun (preferably) or if you don't' have one, you probably want an assistant to hold the wheel in place while you use a breaker bar to undo the nut Then, screw the nut back on 3 turns, and pull the wheel sharply towards you. If that doesn't work hit it medium force with a rubber mallet on either side, or possible behind if you can get there. If that all fails (it shouldn't!) you might need a steering wheel puller
    • So, to next task....the carbon fibre steering wheel was either an expensive factory option or a chinesium special. Either way, I don't like either the flat bottom or thick ring style, so it had to go So...to remove the steering wheel.... First, disconnect battery negative and stomp on the brake pedal for a few seconds. Then, remove the small circular covers on each side of the wheel's rear surround to uncover the airbag clips. You need to push something like a flat bladed screw driver through, to push the steel clip inwards and pull the side of the airbag forward. Once you've done the easy side, same on the centre console side. You can see the tab you are shooting for circled in red Then, disconnect the horn spade connector and for the yellow airbag plug you need to get something small under the black locking tab to pop it out, then the connector releases......airbag is off  
    • @99RS4just wondering if you ever took photos of the footwell lighting / how you bypassed the controller, im keen to haver footwell lighting come on when I open the doors too   
×
×
  • Create New...