Jump to content
SAU Community

Official NSW Skyline spotted thread


CerealKiller

Recommended Posts

Hey mate it didnt look like this did it?

bodyform32.jpg

thats on my desk here at work :(

was in HPI

and it is definatly bodyform.. as thats what the sticker is on the window.

the seats have the GTR logo on em too

Link to comment
Share on other sites

spotted a white 32 GTR with Blitz and something else written up the side in large font... also had QLD plates...

Then spotted almost immediately after that a black 33GTR go past me...

I was also infront of a police officer the entire way to work, and didn't even get a second look! :D

I was in a mazda MX5 :D

I did see him give a thumbs up to another officer though, so they do the same thing that we do :banana:

Link to comment
Share on other sites

Spotted Black R33 GTSt at rootyhill plates GME OVR or some think.

he gets around blacktown a fair bit.

Spotted a yellow r34 gtt with white rims on Douglas Rd yesterday on the way home.

Link to comment
Share on other sites

This morning I spotted a Gunmetal R32 GTR with Gold 5 spoke wheels and blue headlights heading North on Military Rd Neutral Bay, I waved but you probably couldn't see with all the rain :D

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Much less twat-tastic. CF wheels are too garish for civilised use.
    • From there, as the manual says....assembly is the reverse of disassembly, no tricks worth mentioning Much better (for me)
    • In my case, the standard wheel I had was in good condition but the buttons had more wear, so I swapped them across from the original wheel from the car. The plastic rear cover is held on by 4 tabs, and once the wiring is removed you can get access to 2 screws on each side the hold the buttons in From there I just swapped the wiring over. What was interesting is the standard style wheel is 2.0kg but the carbon fibre one is 50% heavier at 2.9kg. It even has a weight inside the wheel at the top to make up for some sort of imbalance in the design. weird
    • Once the airbag is off, to remove the steering wheel.... Undo the 2 plugs into the clock spring, and the horn connector from it's clip. Hit the 19mm nut with a rattle gun (preferably) or if you don't' have one, you probably want an assistant to hold the wheel in place while you use a breaker bar to undo the nut Then, screw the nut back on 3 turns, and pull the wheel sharply towards you. If that doesn't work hit it medium force with a rubber mallet on either side, or possible behind if you can get there. If that all fails (it shouldn't!) you might need a steering wheel puller
    • So, to next task....the carbon fibre steering wheel was either an expensive factory option or a chinesium special. Either way, I don't like either the flat bottom or thick ring style, so it had to go So...to remove the steering wheel.... First, disconnect battery negative and stomp on the brake pedal for a few seconds. Then, remove the small circular covers on each side of the wheel's rear surround to uncover the airbag clips. You need to push something like a flat bladed screw driver through, to push the steel clip inwards and pull the side of the airbag forward. Once you've done the easy side, same on the centre console side. You can see the tab you are shooting for circled in red Then, disconnect the horn spade connector and for the yellow airbag plug you need to get something small under the black locking tab to pop it out, then the connector releases......airbag is off  
×
×
  • Create New...