Jump to content
SAU Community

Official NSW Skyline spotted thread


CerealKiller

Recommended Posts

1) Silver R33 GT-R on Greystanes Rd > Gipps Rd this morning.

Very responsible driver.

PLUS

2) Silver R34 with black c/f bonnet turning right into Campsie Centre carpark

Link to comment
Share on other sites

Seen 2x R34 4 Doors following me on the freeway F3 (M1) yesterday , the first one turned off at Berowra exit ( old pac run maybe ) :yes: the second followed me all the way to Kariong exit but not sure where he went lost him at mooney mooney bridge, didnt get close enough to see the plates ( had a blonde chick in the passenger seat )

Link to comment
Share on other sites

Spotted jasmine (34GTV) at warriewoos again going past the autobahn :)

P.s sounds muh better now with an exhaust... None of this stock rubbish ;)

Haha aw I didn't see you, were you in your 34?

And yessss it's turbo now as well :P

  • Like 1
Link to comment
Share on other sites

*jasmine*

I thought it sounded a bit odd when you passed me, I was going to wave but I was in my territory and well, would of just been akward for both of us.... probably more me not getting a wave back hahaha rims look good too :yes: and if I was that observant, I would say you even changed your number plates from pink to red, to match the 37SL's???

Edited by kaneryan
Link to comment
Share on other sites

*jasmine*

I thought it sounded a bit odd when you passed me, I was going to wave but I was in my territory and well, would of just been akward for both of us.... probably more me not getting a wave back hahaha rims look good too :yes: and if I was that observant, I would say you even changed your number plates from pink to red, to match the 37SL's???

haha yeah i would not have recognised you, so that would have been awkward :P

and noooo didn't change my plates although I'm so over the pink and my plates in general as its not really a GTV anymore :closedeyes:

Link to comment
Share on other sites

I'm colour blind lol

Haha could've been mine, Ricky's mate also, asian and I wear glasses haha, got.volk gtu which look like bbs lm meshes. On another note spotted Ricky on Hamilton heading home :)

Link to comment
Share on other sites

Haha could've been mine, Ricky's mate also, asian and I wear glasses haha, got.volk gtu which look like bbs lm meshes. On another note spotted Ricky on Hamilton heading home :)

Does ring a bell :)

I was in a purple homo coloured r33 with gtr wheels and gate of course lol

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Hi everyone, I bought the Redline diff oil and the seller has sent me Redline 75W90NS even though that’s not what’s pictured.  I’ve already booked a hoist to go and change my diff tomorrow but I’m not sure if the NS is ok for the rear diff in a R34 GTT I think the NS does not have any slip modifiers so would that be an issue?    thanks in advance 
    • Not easy to find pics from 15 years ago, but here is a partial one. Keep in mind that it curved immediately from the airbox, then kept a straight line for the MAF to read correctly, followed by a 45 degree bend straight down to the turbo. This connection was the most difficult as it had to twist as well as bend to meet the almost vertical straight section of the intake.
    • Yes, well, wrt a wheel alignment, there are two types. Either: You have very little added adjustables, in which case the alignment can be done by anyone in any tyre shop or equivalent, and will only take 30 minutes, and so there is no reason to even consider leaving the car there. OR: The alignment is a major exercise because you have adjustables everywhere and so you will need to be taking it to a shop that is skilled and experienced at setting up race cars and the like, and you won't need to worry about leaving the car there.
    • does anyone know the specs of the R35 master cylinder, rear ratio and knee point? the BM57 is a 0.4 rear ratio with a 435psi knee. I'm looking for someone with a much lower knee pressure. the piston area of the R35 brakes isnt that big so might not work for me but this is interesting.. the other option for me is a GU patrol master cylinder and booster and do the prop valve externally.
    • It sounds like by avoiding maintenance you may be doing more damage than a hypothetical guy in a workshop taking it for a spin. Not sure if you are just being paranoid or things are actually that bad in the US. Find a reputable shop not run by dickheads. Look for people that take pride in their work. Stick around for the day if you have to
×
×
  • Create New...