Missing Teflon Vacuum Line From Blitz Boost Controller

[Deano45]

I have a Blitz SBC ID Spec R boost controller and am missing the teflon line that gets teed from a vacuum line into the control unit (i am assuming this is for the map sensor). Does anyone know where I get buy some replacement line from?

I have been trying to work out a way to join the teflon line from the back of the control unit to normal silicone hose. Will this work?

Any help appreciated.

Edited October 15, 2009 by Deano45

[Deano45]

This is the line that I am missing:

[mad082]

how does it connect to the "teflon joint" in the picture? if it simply pushes on the you could just get some vacuum hose from autobarn or somewhere like though.

[Deano45]

how does it connect to the "teflon joint" in the picture? if it simply pushes on the you could just get some vacuum hose from autobarn or somewhere like though.

The line pushes inside the teflon joint, so normal vacuum line wont fit.

I'll try to post up some more pictures tonight when I get home.

[Wheezy]

Should be able to get some autometer branded line from any auto parts store. WIll cost under $10 iirc.

Just take the EBC in there and the T piece to make sure you get the correct OD.

I have the same EBC, good choice

Cheers

-Jez

[Deano45]

Should be able to get some autometer branded line from any auto parts store. WIll cost under $10 iirc.

Just take the EBC in there and the T piece to make sure you get the correct OD.

I have the same EBC, good choice

Cheers

-Jez

Thanks for the tip, I'll check it out

[doo doo]

If you're really stuck i've got a spare length left over from trimming it- i'm in bris but will post it no probs. Can also make little barbed fittings for you if you need to modify fitting it up. PM if needed.

Andrew

[dazmo]

Enzed or Hydrulink stock the teflon line and the push in joiners to suit mate in various sizes you should have no problem getting some from either place.