Car Wont Start

[SCR34M3R]

Hay guys

Finally got a RB26 into my car, but it wont start.

I checked spark and thats fine.

Im not getting any fuel out of the injectors (there is fuel in rail thou), I put multimeter on at the ecu to check if power is sending, and its only getting 0.3-0.5volts. Im not sure what it is spose to be.

Will also be getting a timing light tomorrow to check timing.

Any one got ne ideas for me to check?

Cheers

Justin

[StealthX]

Check injector harness, ECU ground, fuses/relays and ECU plugs...

[SCR34M3R]

Just been doing some reading in the service manual, And im not sure if i plugged a resistor pack in. Does any one have a pic of where it is and what it looks like?

Cheers

Justin

Edited October 18, 2009 by SCR34M3R

[StealthX]

No pic from me, I own an x-trail

Your service manual should tell ya what it looks like, check out the electronic section, more specifically, the fuses and relays.

Should just be in your fuse box in the engine bay.

Good luck man

[Moodles2]

Just been doing some reading in the service manual, And im not sure if i plugged a resistor pack in. Does any one have a pic of where it is and what it looks like?

[SCR34M3R]

Thanks mate, didnt have one, but got some resistors from jaycar and made one up. It now runs YAY.

Just think its in limp mode, sounds like limiter at 2k or just over.

Cheers

Justin

[barney]

Thanks mate, didnt have one, but got some resistors from jaycar and made one up. It now runs YAY.

Just think its in limp mode, sounds like limiter at 2k or just over.

Cheers

Justin

check the afm's.

[SCR34M3R]

ne one know how to test if afm is stuffed?

[SCR34M3R]

doesnt matter, found out there was no wire's going into the ecu for afm's, now running sweet

[StealthX]

sweet, well done!

happy boosting!