Jump to content
SAU Community

Fs: [vic] T04z Copy Turbo, 1.00 Rear, Vband, Garrett Split Pulse Rear Housing $250


Recommended Posts

Hi All,

Removed this due to going with a bigger turbo.

It's a T04Z copy turbo. I believe it was purchased from Rotormaster.

Has a genuine Garrett split pulse rear housing, 1.00 rear and Vband clamp.

Very little shaft play, but it is a little smokey at idle so needs a seal kit put through it. Still spools and boosts very well.

After $250.

Pickup available from either Cheltenham or Reservoir or I can post at the buyer's expense.

Thanks,

Justin.

251020091018.jpg

251020091017.jpg

251020091016.jpg

251020091019.jpg

Link to comment
Share on other sites

I should point out, the Garrett rear housing is brand new, and has not been used.

Reason it has a Garrett rear is because I bought a brand new Garrett turbo. Turns out the rear housing dimensions were identical on this and the Garrett, so rather than stuff around with the dump pipe, I just kept the rear housing off this turbo on the Garrett.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Latest Posts

    • I am using a pull nismo coppermix twin in an r34 getrag box, had both the standard slave and  then the nismo one. Adjusted pedal to get bite point how I wanted , it is on the higher side, but would fully disengage past half way down.  I also read that the nismo slave won't work but I had no issues with the stroke, might become one later as clutch wears but 2+ years of happy motoring so far.  Take the above as one input only, specially as my setup is a bit unique in that I am using an S15 clutch master , cefiro clutch pedal, custom braided clutch line. Lots of variables at play. 
    • Oh for sure, I'm just recounting my thoughts 😎 I'm not what you've got there to fuzt with.... likely my first idea was on the money -- rebuild or replace connectors. You can get a lot of connector stuff here  -> https://www.rapidcables.com.au/ Didn't look in the boot of mine, because I replaced these when I renewed the pump (plastic of connectors had gone brittle) edit: what I used... https://www.efihardware.com/products/2120/Deutsch-DTM-Connector-Kit-6-Pin ...cheaper... https://www.ebay.com.au/itm/364900039138
    • In no way was i suggesting it’s your fault mate. The trailer cable has a plug that I removed. I will have a closer look, but I did remove the trailer wiring cable with the tow ball as I don’t need it on my silo. i have replaced the fuel pump already there’s no need to remove the cradle again I can see the wire colours from it in.
    • Mint. Good to see another GTSt getting love and coming back to life. Did I miss what colour you are going to wrap it?
×
×
  • Create New...