Jump to content
SAU Community

Recommended Posts

I headed down to AIR tonight (06Dec) to lend a hand to Shaun, Ben & co as they were running the 'Boost Worx' backed yellow 2JZGTE powered Supra (ex-RPM car).

Ben ran a string of low 11's @ over 127mph before finally getting the car to run closer to its potential with a PB of 10.8 @ 125+. The mph was down on the earlier passes as an IC hose blew off going into 3rd gear. The car should run closer to 10.4 with a few more tweaks.

All passes were on ET Streets (DOT approved) I'm not sure if they qualify for the HPI Street Drag Challenge or not?

I'm sure most will agree that the 2JZGTE is an awesome engine. Ben's Supra runs a dead stock internals 2JZ.

Another car worth mentioning was the factory standard new 3.5L V6 Magna (base model) whose female driver ran back to back 14.8 - 14.7 mid 90mph passes (best of 14.7 @ 96mph). The only mod was a slight change to the air box feed.

Link to comment
https://www.sau.com.au/forums/topic/29343-boost-worx-jza70-supra-runs-108-125/
Share on other sites

Yeah mate sure have!

I remember reading articles on the MKIV JZA80 Supra when it was first released in Japan. It was my #1 choice when I got interested in imports back in the early-mid 90's. They were a touch too expensive back then though :) Hence I got the Skyline instead. I've gone too far with the GTS to start again now :)

Hip,

Brand new ET Streets & a good suspension aligning session made a huge improvement on the strip.

ET Streets are a drag radial tyre made by Mickey Thompson. They're DOT approved which technically makes them street legal.

mickeyt.gif

"There's a simple way of identifying whether or not a tyre is legal for road use. If it has "DOT" or "E" written on the sidewall, it's passable - no probs. DOT is the US abbreviation for the Department of Transport, while "E" is the recognised European compliance symbol. Having said that, it wouldn't be unthinkable to get pulled over by the police for supposedly "bald tyres" - regardless of their technical legality."

The car is with Boost Worx now as the mechanic linked with the car moved from RPM to set up his own workshop. So the car moved with him.

Tim,

I'd say traction would've been a huge factor in who hosed who on the street! Neither cars have/had a lot of traction on road rubber. Ben mentioned turning the tyres @ 180+ on the road.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • So, the other thing I've sorted is a baseline dyno run up at Unigroup's new location. The auto trans was a little unco-operative by both shifting down when the throttle was floored on the dyno (so Mark had to ramp it up more slowly than in a manual) and also by shifting up at 6,000 even in sports mode instead of the indicated redline of 7,000 Still, on a hot day it made 240rwkw at 16psi which seems about right for 300kw (400hp) through an auto at the wheels.  The shape of the curve is not quite right because it was not full throttle to about 4,500 to stop it kicking down, but until I can get a tune on the auto trans control this was the best we could do.....full boost will be well below 5,000 once that is sorted, I'll get some data logs when I can to confirm For comparison, the R32 made 255 at 12psi (at 4,500) on the same dyno with tune, n1 turbos, cam gears, big exhaust but otherwise all standard so the v37 is likely a little better out of the box. One thing that is very clear is that the standard water to air intercoolers are not up to sustained use at full throttle in warm ambient temps. After about 5 runs (so only a few minutes full throttle), it was pulling boost and timing and dropping 10-15% power. Unfortunately I didn't get that printout and the Unigroup guys are away at the moment, will try and get hold of it on their return. So, looks like a healthy engine to start modifying and the only real area of concern is the w2a heat exchangers which the aftermarket has plenty of solutions for    
    • I maintain it actually looked really nice in person. So much so that I thought "No, this is illegal" but there it was, clear as day. I think we can easily call the wing and wheels/height to be transformative. Not saying it's better than the GR Whatever, or the 86, or the WRX STI or anything of that sort (the internet says it all bolts up so you can buy best of all worlds?) but it's still at least a thing and not nearly AS bad as people say.
    • That's less offensive than the previous gen.....except for all that ugly black tupperware around the edges. Blerck!
    • I leant out the window recently and took a picture of this new WRX. It looked real damn fine in person. It's faster around a track (stock) than a (stock) GR Yaris. It's much more practical despite being heavier. It's significantly cheaper. This gen tunes really well, much better than others. .... I think they're probably a lot better than people expect.
    • WRXs are a pure pleb boring car these days. You need to get an STI to even get close to what a WRX used to be.
×
×
  • Create New...