Gtr Diff Into Gtst

[maso]

Hey people, need some help. i have a R32 gtst and i want to install a GTR diff in it, im planning on changing the whole rear end in one hit, now the problem is the gtr guards are pumped out more then the gtst ones so im presumeing it wont fit i.e tyres rubbing.

is it possible to put a negertive camber kit so the tyres fit?

Also there was a oil fillup inside the boot (presumeing its for the HICAS), my gtst does not have one of these instead i think you fill up the HICAS through the powersteering reservoiur, will i have to install this reservour into the boot of my car?

are the computers for the gtr and gtst universal?

[talky]

t the differece beetween a gtr diss and a gtst diff???? just remove the hicas all together

[blind_elk]

The reservoir is for ATTESSA, so you don't need it.

ECUs are slightly different - GTR has 2 O2 sensors, and an air temp sensor, which the GTSt doesn't have.

The extra width in the guards of the GTR is to accommodate the smaller offset of the wheels. Your GTSt rims should still fit inside the guards.

[maso]

thanks, so when you remove the hicas what do you do with the hydrolic lines do you join them together or block them off? if im not using the hicas will i still need to connect up the computers, or can i use the same ones, or am i going to have to buy a set to install,

[daisu]

If you are removing hicas, remove as much of the lines/solenoids as you can, and then join the lines together.

You won't need to install any computers as your car already has hicas (and it's associated computers) you will need a lock bar to replace the hicas rear steering.

[maso]

ah k sounds good thanks for the help guys