Jump to content
SAU Community

Recommended Posts

sup guys im not sure if this is the right section to post in but anyways. i was driving my n/a 34 today and i pulled up at a intersection and the engine started idling weird and made the whole car shutter then the engine light came on which has never happened before.has this happened to anyone before? what was it?how much to fix? and should i be worried?

thanks heeps peoples. :(

Link to comment
https://www.sau.com.au/forums/topic/295797-wats-wrong-wif-my-beast/
Share on other sites

most likely ur coil packs playing up if it started to sound like a rexi n ur engine light on... if u wanna confirm it get an engine diagnostic done n it will spit out the codes 4 ya... best bet is get a set of splitfires :( ... n at the same time sum plugs if they need changin

Jas is right, we have both had this problem and we both put splitfires in, there awesome but expensive (about 650 atm) and if you like there are plenty of guys that will help you install them, easiest thing to do, if your not 2 far away i'll do it for you. If you cant afford splitfires there are are others that will do the job....

update is it is at the mechanics and the mehanic cant diagnose what the problem is so i have to pick it up tommorrow morning and drive it until problem happens again then take it back to him immediately sound weird too you? do u reckon hes dodge?

update is it is at the mechanics and the mehanic cant diagnose what the problem is so i have to pick it up tommorrow morning and drive it until problem happens again then take it back to him immediately sound weird too you? do u reckon hes dodge?

I'm going to go out on a limb and say he's a moron :happy: - if he had the write equipment he will be able to plug it into your ECU via the connector under your steering wheel to the right and it will give you a code and tell you whats wrong. Also the fact that the problem is spontaneous is a symptom of coil pack failure. A Dyeing coil pack will start failing more and more and in the early stages of failure will fail when the engine is hot or at high revs (where its worked harder and harder)

Where are you located mate?

I'm going to go out on a limb and say he's a moron :happy: - if he had the write equipment he will be able to plug it into your ECU via the connector under your steering wheel to the right and it will give you a code and tell you whats wrong. Also the fact that the problem is spontaneous is a symptom of coil pack failure. A Dyeing coil pack will start failing more and more and in the early stages of failure will fail when the engine is hot or at high revs (where its worked harder and harder)

Where are you located mate?

Not even the right equipment, just a paperclip!!!!! All he has to do is the consult port self diagnosis with a paperclip and read Error 21 off the check engine light :)

diagnostic.doc

Coil packs is the most common issue for R34 GT/GT-T. Get them changed. While you are at it - change the spark plugs (NGK platinum) too @around $15 each from a Nissan dealership - saves the hassle of getting to the spark plug area again later on.

Not even the right equipment, just a paperclip!!!!! All he has to do is the consult port self diagnosis with a paperclip and read Error 21 off the check engine light :P

diagnostic.doc

Well there you go, a paperclip is more useful then your mechanic :P

well today i went to see how my car is going and he still hasnt found the problem so i told him that the coils are probably rooted and he just looked at me like im an idiot he said bring it back on tuesday so im gonna find another mechanic around and iam in portmacquarie like 4hours north of sydney.

well today i went to see how my car is going and he still hasnt found the problem so i told him that the coils are probably rooted and he just looked at me like im an idiot he said bring it back on tuesday so im gonna find another mechanic around and iam in portmacquarie like 4hours north of sydney.

"If" he is the only mechanic in the area. Buy the ignition coils from eBay or any other shop and get him to install it.

Make sure you specifically get the coils for RB NEO engines.

Just to correct you, hes not a moron because the diagnostic thing Nissan uses wont give you a fault code unless you have the engine check light on at the time. If it comes on and you turn the car off the engine light goes away, the only way your going to get the fault code is if the light comes up and you drive to the mechanic and leave the car running while he checks it out... :(

Just to correct you, hes not a moron because the diagnostic thing Nissan uses wont give you a fault code unless you have the engine check light on at the time. If it comes on and you turn the car off the engine light goes away, the only way your going to get the fault code is if the light comes up and you drive to the mechanic and leave the car running while he checks it out... :(

actually, my r34 had had stored the fault code primary ignition failure 21... we tested it when the light was off then tested it again when it came on ( which was litteraly a drive around the block later, lol) just to be sure and of course it was the coils.

Edited by AYW550
well today i went to see how my car is going and he still hasnt found the problem so i told him that the coils are probably rooted and he just looked at me like im an idiot he said bring it back on tuesday so im gonna find another mechanic around and iam in portmacquarie like 4hours north of sydney.

lol hope he didnt think u were refering to the suspension springs as in the coils :(

how often does ur engine light come on??? like 10 mins after start up n then goes away after u turn it off n back on, or go on n off every 5 mins

also does it alwayz shudder n splutter n spit the dummy n stuff or does it come n go???

ive got a set of spare stockies u could try, wack them all in n inspect the plugs at the same time n see if the problem goes away... least then u will know 4 sure if u need 2 buy new 1ns

BUT its way easier 2 just get a diagnostic done if u can... btw u might have 2 use a GTT diagnostic

Just to correct you, hes not a moron because the diagnostic thing Nissan uses wont give you a fault code unless you have the engine check light on at the time. If it comes on and you turn the car off the engine light goes away, the only way your going to get the fault code is if the light comes up and you drive to the mechanic and leave the car running while he checks it out... :)

I'm calling him a moron for jerking this guy around, if he doesn't know whats wrong or he hasn't got the means or the know how to fix it then just suck it up and say so, don't waste ppl's time. When this happened to me i took it to my local mechanic and he had no freaking idea what was wrong and he admitted that he was unfamiliar with imports such as mine.

actually, my r34 had had stored the fault code primary ignition failure 21... we tested it when the light was off then tested it again when it came on ( which was litteraly a drive around the block later, lol) just to be sure and of course it was the coils.

exactly the same as me AYW550..

Because the Tester that my mechanic uses (the guy i go to primarily specialises with imports and most commonly skylines....) can show a whole list of past codes with his tester..... and then his tester can clear all past codes so there is a 'fresh slate' so that all future codes don't get mixed up...so it didn't matter if the engine warning light was on or off

mind you he was telling me that this new tester he had cost him some crazy amount (like 10 grand or something!!) for this thing about the size of a power FC, so if your mechanic uses a different one ( and lets face it, if your not dealing with imports on a daily basis your not going to have a 10k diagnostic tool lying around) then he probably has limitations to the interaction with the ECU. but by all means correct me :P

the engine light comes on about 20 mins after driving it. when i stop it starts to shutter then the light comes on and it goes away when i turn it off and back on. i think i might just buy one of those cord things that go in my computer and if it says error code 21 i can say that it is my coils. and he probably thinks i was talking about my coils coz i just had new springs put in by him.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • @joshuaho96 Hmm considering the drama you've seen/experienced, have you looked into getting a built complete long motor shipped from Australia?  Considering the AUD is basically monopoly money when compared to the USD, at a glance this seems like a good option?
    • Bloody Skylines, they put you through the bloody wringer! Stick at it! Stunning drag strip BTW! Where is it? Can see part of the name on the slip and probably should just Google it!
    • I mean the other day I had to walk someone through diagnosing why their timing belt was walking off the cam gears. At least one of the issues was a bent tensioner stud. Local mechanics have found runout on the CAS mechanism causing weird failures. I'm also no saint here I've documented some of the things I've had to learn the hard way. Something I discovered recently is that my CA emissions catalytic converters weren't even welded correctly to align the downpipe to the main cat and they tossed the support bracket that goes from the transfer case to the downpipe to support everything there. I spend a lot of time chasing down these decidedly unsexy problems and the net effect is it feels like I never actually get to the original objective (flex fuel, VCAM, oil control, cooling, etc).
    • At times with how you make everything sound, all I imagine Americans doing when they see a gtr is standing there looking at it and bashing it with a gun like how a caveman would with a club and hoping it fixes itself 
    • I think this is just a product of how the US market works for this stuff. Shops are expensive and there's no real way of knowing what kind of results you're going to get, people don't really have the institutional knowledge. I have heard too much at this point to really put faith in anybody "full service" except maybe DSport and they aren't really a full service kind of shop. If you go to the right place I have no doubt they'll get it right for you. Some locals have set it up right but the cost really is nuts and even now they're still fighting issues. And you know I'm a crazy person who thinks things like twin scroll, relatively short low-mount cast headers, PCV recirc to intake, recirculating BOV, right-sized for ~400 whp, MAF load, validating all of that to a standard comparable to OEM test programs, etc are relevant. For what it's worth, multiple local owners at this point have been stuck in a perpetual cycle of blowing a motor -> getting someone to rebuild it -> some missed detail causes the bearings to wipe and spin just outside of break-in mileage or drop valves or some other catastrophe -> cycle repeats. I usually only find out about this because I'm perpetually helping random friends with diagnosing car troubles, Skyline or otherwise. The single turbo stuff if I'm honest is mostly secondary, it just doesn't seem to achieve the numbers in the ~2000-3000 rpm region that I would expect given the results I've seen here or in Motive's videos. I don't really know what we're missing here in the US to be causing this. Lots of people like to emphasize the necessity of finishing the project first and foremost, but I'm not made of money and I can't afford to be trashing a 15k+ USD engine build with any regularity. Or spending my relatively limited garage time these days unable to triangulate problems because too much was changed all at once. Also, even if it isn't a catastrophic failure I would consider spending the cost of single turbo conversion with nothing to show for it to be pretty bad. 
×
×
  • Create New...