Estimate Power?

[ako299]

hey

i have a R32 gtst

mods on the engine i have done

greddy fmic

3inch exhaust

cold air intake/pod

walbro 500hp fuel pump

greddy eboost running 10-14psi

stainless exhaust manifold

catch can

bov

pwr ally radiator

it is gettin apexi SAFC fitted and tuned this friday just wondering how much power i should be expecting if anyone knows? thanks

[Birds]

The catch can + radiator + blow off valve are sure to count for alot! Too many variables in it mate...engine condition...dyno being used...tuner...what it's tuned for. Circa 200rwkw if you're lucky?

[Mid_Nite_R33]

with a good SAFC tune you'll get about 170 RWKW out of a RB20 in good cindition..

[scathing]

You should get at least 1rwhp.

It's a 18-20 year old engine of unknown history. Even if it were dead stock it would be impossible to guess how much power it makes now.

Edited November 18, 2009 by scathing

[fuzzy_scuz]

+1 above

definately above 1kw

[PM-R33]

On 14psi i would think anywhere from 170-180rwkw depending on the condition of the engine and depending how the SAFC is setup.

[mad082]

4.35 jiggawatts at the wiperblades

out of curiosity, why did you chose to go a SAFC over a remap? the cost of purchasing and tuning a SAFC wouldn't be that much less than a remap, however the remap would give much better gains.

[bozodos]

you'd probably find that it came with it marc - a fair few RB20 powered Skylines I've seen have, since a few years ago remaps weren't as common and they always tend to run a bit rich.

[R31Nismoid]

Same as everyone else

Please read the Dyno Results thread, located in the Forced Induction section.

Thanks.