Jump to content
SAU Community

S15 Spec S Gt, Auto, Sydney

JunglBoi

By JunglBoi,
in For Sale (Private Whole cars only)

 Share

Recommended Posts

JunglBoi Enthusiast

JunglBoi

Posted
Posted

hey guys

just helping my sister sell her car

http://www.carsales.com.au/all-cars/privat...&__Qpb=true

car has only been purchased feb this year from col crawford motors, and shes moving overseas to work so needs to sell the car

she has only driven about 5000kms on it since she bought it because she has another car she uses for work

its completely stock and is serviced regularly with full service history and runs well

Link to comment
https://www.sau.com.au/forums/topic/297228-s15-spec-s-gt-auto-sydney/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      R33 GTR lift points for hoist

      By Duncan · Posted

      FWIW the depth of the groove in the rubber pad is not super essential, the blocks are rubber and squish a bit. If you are worried an angle grinder will make a deeper groove quick smart
    • GTSBoy
      R33 GTR lift points for hoist

      By GTSBoy · Posted

      I mean, if you were to move the jacking points away from the original location, that is, away from the wheels and closer to the centreline of the car, then it will be more likely to overbalance and tip off the supports. Same as we talked about before. I was talking about moving for-aft. If the sill is bent outward or inward, then the car would obviously look unstraight from the outside. Hopefully that hasn't happened either. Again, you can do comparative measurements from the chassis rails to see if there is much deflection.
    • sunsetR33
      R33 GTR lift points for hoist

      By sunsetR33 · Posted

      Can you elaborate what you mean with your first sentence? I meant move as in the bulge kinda seemed like it got pulled "outward" meaning it got pulled down and to the side with the jacking rail itself, so the load bearing bulge now sits lower than usual and is not level with the sill on the other side of the jack point. Either that or the jacking rail just got pushed in a good bit.
    • GTSBoy
      R33 GTR lift points for hoist

      By GTSBoy · Posted

      As well as being risky WRT tipping off anyway. Yeah, I wouldn't expect it to move. Just measure from the rear one to the front one on the good side, then measure that same length on the wrecked side. You will find the notches in the pinchweld, and the jacking pad. Just spray a spot of marker paint or something there.
    • sunsetR33
      R33 GTR lift points for hoist

      By sunsetR33 · Posted

      but any other area than the bulge you are talking about will just cave in then? The front driver side is pretty bent so I don't know if that will work the way it is now. I can still kinda make out where that bulge is/was but it looks like the position of it also changed due to all the mistreatment? Hard to tell
×
×
  • Create New...