Jump to content
SAU Community

Recommended Posts

hi i got a problem with my injectors leaking,seaping fuel out on inlet manifold i've changed bottom o'rings twice and even changed top ones with genuine ones all correct size could they be cracked? but they all leak, some more than others. any help appreciated thanks, sorry should mention they are stock rb20det ones

Link to comment
https://www.sau.com.au/forums/topic/299439-injectors-leaking/
Share on other sites

The bottom o-rings dont provide a fuel seal so no point in changing them. The top o-rings which provide the injector to fuel rail seal are the important ones and are not visible until you pull the injector out of the rail. Dont confuse them with the rubber spacers.

The injector bodies can leak, that may well be your problem. I've heard you can get them repaired (but not confirmed it), but its an ideal time to upgrade if you power plans require more capacity, but you'll need programmable engine management to run different sized injectors.

yes all are leaking some more than others,not pissing out but enough to catch on fire. if i do upgrade to gtr injectors would car still run good or would have to get a remap and tune?

Yes you will need a tune, you can't just change to bigger injectors and expect the stock ECU to work fine, just get Nistune www.nistune.com , works out cheaper than getting remaps, and at least you could get away with resizing your injectors without a new tune.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It was roughly 3.5 hours.    car went in around 11:00 and I was done around 2:30 He did the initial runs, install the BC and then Nistune install and tune.  The best part was sitting in the lobby and hearing the skyline on full throttle at the dyno 😂😂
    • Glad it all went smooth. How long did the tuning process take?
    • Yeah that was kind of the same feedback my tuner gave me.  the boost tee is until I can sort out my plan for the electronic boost controller and what I’d get, where I’d mount the dash etc.  I’m happy with this until I can figure it out. Not a big fan of the A-pillar gauges. I’d like to get a clean install of the boost gauge - something digital like GFB.  Something like that might fit neatly where the ashtray is and look clean. I feel like replacing the OEM triple gauge is a bit extreme for a weekender like my skyline. And it’s not making crazy power to need all the additional sensors/gauges. 
    • I'm about to swap my box to Tremec T56 Magnum F & initially thinking of re-using my DCS twin plate (can get it re centred for the bigger spline) but it's been called out the box will be noisy (rattle) as the clutch is unsprung.  So I'm doing as much research as possible. I'm not so worried about holding the power as I'll go the track version which on paper will hold the maybe 1000hp I make. It's the longevity I worry about. DCS told me they don't use a sprung centre as it's just something that can break. The uni clutch has a very complicated sprung centre. Any one had or heard about any issues with it failing? Thanks in advance.
    • Auto is at least 10% (from my real, actual experience with different torque converters and manual on the same setup) ~185rwkw at 11.6psi (peak!) is entirely what one would expect without a FMIC or anything else on the intake, it does bleed off towards the higher RPM so it's what, 9psi there? Note: There is nothing that can be done about this with a manual boost tee. If you want to hold it steady and gain more top end, well - You will need electronic boost control.....
×
×
  • Create New...