Jump to content
SAU Community

Recommended Posts

post-78856-0-46410500-1334356824_thumb.jpg

Pretty sure I spotted this leaving town yesterday at about 6:45 am on the Barton.

Was hard to tell as it blends in with the traffic.

Roof racks were loaded to the Max Power and it looked like it may have been on some sorta mission... hmmmmmmmm.

.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/733/#findComment-6314099
Share on other sites

saw a white r33 out front of my place stop and proceed to do a skid when they saw me with my bonnet up. I would have waved but i was jump starting the cressy. You should probably just wave next time.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/733/#findComment-6316612
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ye, in terms of bolting up the "Conversion" from a GT to a GTT is effectively "Use GTT parts for everything" Except the subframe itself, because you won't want a HICAS/4WS subframe. Remember your ABS system will be different too, thanks to GT being the S15 3 sensor system, instead of the R34 4 sensor system for wheel speed. I do not know how people get this to work given R34 diffs do not have a provision for an ABS sensor (they are on the tone wheels of the axles). I assume***** people use S15 gear/R34NA forever when they realize this - Or they convert it to a rear diff/axles that are R33 style which I presume has the singular speed sensor on the diff itself, but then you have to wire it all in and...and... and...
    • Foreshadowing was never so easy.
    • The ones in brackets are the first stages of tightening. I usually aim for the middle of the range. They give a range because it's actually not that critical to hit exactly the right bolt tension. Enough is enough, and too much is too much, and the range given is inside that range. Half of the bolts in the suspension are problematic for putting a torque wrench on anyway, so just get done up to mechanic tight  and spanner checked a week later.
    • Is the problem that we just disconnected the line, does it need to be plugged? I’d rather not buy another master cylinder
    • Clutch is same same. Tailshaft is not. Diff will drop in. Half-shafts will not mate up (5x1 on turbo, 3x2 on NA). There is also the strong possibility that your auto NA gets its speed signal from the sensor on the diff, not the gearbag, and that will leave you without a speedo. You can do all this, you just have to do a lot more than you thought.
×
×
  • Create New...