ecu diagnostics using consult port

[_turtle_]

hey guys i read on the skyline faq that u could put the ecu in diag mode by shorting the two terminals for 2 secs in the diagnostics connector. i followed the diagram:

|O|OO|OO|OO|

|X|XO|OO|OO|

and stuck a paper click into the pins marked "X". nothing happend. can anyone verify that the diagram is correct, or is it something i'm doing wrong? the two pins were empty, i just stuck a paper clip through, each end of the clip onto each pin. btw i had the ignition on too. nothing. whats suppose to happen next? main reason i want to do it is coz its the easiest way to reset the ecu.

thanks

[blind_elk]

its the pair in the top right, not bottom left.

Actually, simplest way to reset ECU is disconnect battery and pump brake pedal, or open door - anything that will draw a current.

[teka]

sounds like your talking about doing the diognostic's on the DELCO engine managment, never heard of it on a Skyline through, tell me if u do get it to work.